In my experience kicker always makes good quality products, this goes for this product as well. The only thing that I found at fault with it is that it doesnt fit the kicker 1/0 cable that I am running well. Had to trim the ends a little bit to get them to fit good. Would buy again.

I used this as it came inside a Kicker amp wiring kit I got from a popular car stereo online retailer. I'm using it with a 100 amp fuse and 4 gauge Kicker brand cable to supply power to a 5 channel class AB/D 150w x2/ 500w x1 RMS MTX amp that has three 30 amp fuses on-board. It sits under the hood of my '09 Impreza along the rail above the inner fender on the driver side of the engine compartment up top, right under the hood. It barely fits in this spot making the cover a little difficult to remove, but it is a clean install and it's up out of the weather. It does everything perfect, and looks good too.

I like having the option of using either a full size fuse or the mini ANL.
It makes a good solid termination for your cable but, plan on using tape or some other method to hold the cover on. The little snap in tabs are just to small to hold it on by it self.

Does the job. Holds different style fuses. Lid/cap doesn't want to stay on, not that big of a deal.

It works, but too expensive. I got one of these as a gift, and not like it's a bad product or anything, but waaaaay to expensive for a fuse holder. Save yourself some money and go buy a cheaper anl fuse holder.

A heavy duty fuse block that's very well made. Fit and finish are second to none.

Only problem I have with it is that the plastic cover likes to easily pop off. Other than that, I have no complaints. Would still recommend.

Everything in my car when it comes the stereo is Kicker! From the speakers down to the Fuses! I love this fuse block, it dresses up the engine compartment and is very strong.

Works great holds bigger amp fuses and even those smaller amp fuses you may need fits 0 and 4 gauge perfect.

Its an ANL fuse holder...it does the job but I chose it because it is going to be seen and it definitely looks good on a beauty board

Highly Recommened this fuse block is the best of the best

Kicker always makes a quality product.
I lowered value just because I think most fuse blocks when purchased by themselves cost too much.

its works fine, the only thing i dident like was that the plastic cover is only held on by to plastic clips, no screws. it has not fell off in 6 months but its not on there very good.

I have 2 of these fuse holders and they are serving me well. I run two amps so I have a lot of connections in my wiring (main fuse, dist. block, fuse block for each amp) I check my connections every so often and these never need tightening. I also like how they'll accept 2 different types of fuses for flexibility. Overall excellent fuse holder, I have kicker wires running into and out of it and I've had no issues with it in a years time.

I had this over just little over 2 months. My amplifier is not turned on at all, i smelled burning when i opened up my hood, the fuse block is burned. I had 300 amp fuse in side, it's the craziest thing ever happened to me before. I still have a stinger fuse block, and just going to replace that with this Kicker one, Kickers are good, but stuff can always happening no matter what you got. Now my fuse block is just going to be in the garbage now. It was crazy totally burned the fuse block apart. Look for a new one now in case I burned the Stinger one.

This is the best fuse holder i have ever owned. The rubber grommets come out and the little rings inside do to for easy use of power wire from 4 to 0 gauge power wire. It's well worth the 30 dollars when u take the top off its not loose like normal holders it stays on nice and tight so u really gotta squeeze the middle for the tabs to pop off. Best holder ever if u get it u will love it! I have been using mine for 6 months now