Showing 1 review for Kicker 11DS65.2
|Customer Review Summary for Kicker 11DS65.2|
|July 14, 2012||Very Happy with these||
2 of 4 people found the following review helpful:
RMC from OCNY from Campbell Hall, NY
I wanted to replace the speakers in my wife's car which is a '99 Honda Accord LX Sedan and wanted to spend the least amount possible for the best performance. I chose these because of reading other good reviews and I picked them up used for a very low price that I could not pass up. I'm going for true low budget car audio.
Replaced factory front door dual-cones in a '99 Honda Accord LX driven by 15W per channel RMS built-in to the Kenwood head unit. Outer and inner door skins were completely covered in generic Dynamat super covering all openings to seal off the door. The woofer did NOT fit the factor speaker brackets by a hair - the 6" version DS60.2 would have dropped right in. So, I cut some mounting rings out of some 1/4" birch I had laying around and painted it with some multi-purpose sealer to keep it from disintegrating when it gets wet. I used 1/16" thick adhesive backed weatherstrip on the back of the woofers to seal them against the new mounting rings. The mounting rings are sealed against the door skin by 2 layers of the generic Dynamat super. I can't stress enough how important it is to properly mount and seal any woofer/mid when installing. Poor installation can make an expensive speaker sound like crap. The tweeters were mounted to the trim piece that covers the side mirror mounting nuts and wires. I used the surface mount angle cups and directed them as much as I could to the opposite side passengers head location. The crossovers are mounted with wire ties to an existing wiring harness on the inner door skin in an area that was under the armrest on the door panel.
With some tweaking of the crossover's high level switch, and the headunit's 3-band EQ & bass boost, the frequency response became surprisingly smooth. I tuned the EQ using a PA2 audio 1/3 octave analyzer, and then by ear though I probably would have reached similar results with just tuning by ear. The mid-bass is tight and deeper than most other 6.5" components systems I've installed, but not as deep as the old school Boston Acoustic 6.5Pros that I've had in a previous car, which I expected. The mids and highs are surprisingly detailed and dynamic. Overall, they sound outstanding for an entry-level component set. They are plenty loud using the head unit's power and get way too loud before distortion from clipping was heard. I really don't see a need to amp these as they seem to be very efficient.
When I told my wife I was going to replace the speakers in her car she said "Why? It sounds fine to me." Now, after the install, she was blown away by the difference in sound quality. I definitely recommend these speakers. Now it's time to find some used 6x9s for the rear to get rid of the muddy lows the factory speakers produce.