MTX Audio reQ-5 (re-Q⁵)

Warranty and Return Policy

1 person rated the MTX Audio reQ-5 (re-Q⁵) and gave it a rating of 4 out of 5

Have you used this product? Click here to review it!

Review written by MiCHAEL from Hurst, TX

Works very well but has a couple of problems and the manual could use some attention. Installed in '07 Tundra driving Sony 4-channel and a sub amp. I'm not using the supplied aux input (yet).

One major issue is the 15-second off time on the auto-sensing trigger (to turn amps on/off). This is too short and will cause amps to turn off between songs when one song ends or starts quietly. Once level increases enough, ampt turn on but you miss part of the song. I ended up using accessory B+ and bypassing sensing circuit. This timer should be closer to a minute or two.

The supplied fuse holder is subject to poor connection (e.g. hitting road bumps) causing pops and amp shutdown - replace it with a better one.

Each channel has two inputs to the unit (8 total + a sub). With a "normal" factory HU, half of these are unused and clutter up the installation. I bridged the sub input as the manual suggested and clipped the unused wires at the connector.

There are two surface-mount red LEDs near the power-on LEDs. There is no explanation in the manual but they appear to be clipping indicators.

The "front/rear sub level" switches are poorly documented. I can't really tell what they do. Are they high-pass x-overs? Controlled by the sub x-over frequency? What frequency is the -3dB, -6dB at? Is it volume sensitive?

There's no info on MTX's web site and MTX has not responded to an email query about these issues. Since this is a new product, hopefully we'll see answers soon.