4-gauge power and ground wiring is required for installation. Contact us for information regarding a discount on select amplifier kits when purchased together with this amplifier.
The name says it all.... I used to run a Lanzar Max 232 with 500w RMS and 1000w peak. Doesn't even compare to this amp. Hifonics amps such as the TXi 6008 rms at their peak, so 600w Peak = 600w RMS, very important that you look at that continuous power.
So far so good (put it in about 9 hours ago), it gets warm, but I also had it booming for about 35 minutes straight so yeah, it is meant to pound, so I have been torture testing it. Great Amp.
April 23, 2008
Very Good for the Price
Overall
Durability
Value
Features
Design
Usability
Review written by Anthony from North Las Vegas, NV
I recently installed this amp running it @ 2 ohms stereo on two 10 inch pioneer dual voice coil 4 ohm subs that I also purchased from sonic. I have to say so far so good. The amp runs a little hot, but has not gone into protect mode yet or blown fuses. I'll just have to wait and see. For the money, it seems like a steal!!!
e2 1000W Single Amplifier Wiring Kit • 9.5mm power/ground (equivalent in strands to most other "4 gauge" kits) • 17' Twisted Hex RCA Interconnec Cables • 17' power and ground
this is the 5th time i have used sonic and i have no complaints about the products, shipping, prices, or the staff. Everything that i have experienced has been beyond expectations. thanks again