8-gauge power and ground wiring is required for installation. Contact us for information regarding a discount on select amplifier kits when purchased together with this amplifier.
Review written by 70Chevelleman from Whispering Pines,
This was my first amplifier install, it went very smoothly, hooked up the speaker wire, RCAs, ground, power, remote wire, tested the power fuse w/the fuse out of the amp, then plugged in the fuse and it turned on, no prob. I have it hooked up bridged 4ohms, to a 10"Kicker Truck Sub with the level at about half in my 97'F150 and it hits really hard :D
May 26, 2009
Polk Quality
Overall
Durability
Value
Features
Design
Usability
Review written by dobropet from Texas City, TX
Have this amp pushing 1 polk 10" sub nicely, and could possibly push 2 more 8" subs w/very little effort. Good quality amp for the price, not bad for 4 ohm speakers......
May 20, 2009
Crunch P500.2
Overall
Durability
Value
Features
Design
Usability
Review written by maxwell from fresno, CA
amazing little amp, it, along with several other crunch amps I have owned, have been pushed to their limits for long periods of time, and have never failed me once.
May 18, 2009
Nice!!!!!!!!!!!!!
Overall
Durability
Value
Features
Design
Usability
Review written by josh from Charles City, IA
this amp is a nice little amp for the price. i have it powering one 12 inch MTX thunder series and it hits! i recommend this amp for anyone with a little cash to spend!
e2 400W Single Amplifier Wiring Kit • 6.5mm power/ground (equivalent in strands to most other "8 gauge" kits) • 17 ft. Twisted Hex RCA Interconnect Cables • 17 ft. Power and Ground Cables
