Expert Service 1-877-289-7664 [Hours]
Kicker VS12L34 (11VS12L34)
4 Ohm: 12" Vented Sub Enclosure Loaded with 1 Solo-Baric 12" L3 S12L3 Subwoofer (VS12L3-4)
The DS and VS Series vented enclosures combine KICKER’s award winning Solo-Baric subwoofers with computer-modeled and human fine-tuned enclosures to offer a level of bass performance never before thought possible from a commercially available, ready-to install subwoofer system.
Designed for use in SUV and sedan type vehicles, these enclosures offer you several mounting options. You could (1)mount it all the way in the back of the vehicle, pointing forward, (2)mount it behind the seat, pointing to the rear, or (3)mount it along the side wall with the port pointing to the rear.
- 12" Solo-Baric L3 Series Subwoofer
- Power Handling:
- Peak: 800 watts
- RMS: 400 watts
- Enclosure impedance: 4 ohms (Wired internally in series to final 4 ohm impedance)
- Titanium deposit impregnated cone woofer with rolled outer edge
- Santoprene rubber surround
- Full coverage back bracing
- Poly-cotton semi-progressive spider
- Spiralead™ tinsel-lead technology
- Highly-efficient UniPlate™ pole-piece/back plate
- Heat-reducing T-cut top plate
- Solid pole piece
- Cast-aluminum basket
- Spring loaded terminals
- High-temp dual 2 ohm voice coil
- Frequency response: 20-100 Hz
- Sensitivity: 86.3 dB
- Authorized Internet Dealer
- 1-year Manufacturer's warranty (subwoofer only)
- Single 12" Vented Sub Enclosure
- Carbon-fiber front panel
- Solid wood box
- Embroidered Kicker logo
- Combo vent/terminal cup
- Oversized port
- Dimensions: 14-11/16"TD x 18"BD x 18-3/4"W x 16"H
If the loaded enclosure or amplifier and subwoofer package includes more than a single subwoofer, then this is the total RMS power handling for all of the subs combined.
The RMS power is the amount of power the speaker requires to operate safely and properly. RMS Power Handling refers to the amount of power a speaker can handle on a continuous basis. We recommend giving your subwoofer(s) 75% - 90% of the recommended RMS rating.
If the loaded enclosure or amplifier and subwoofer package includes more than a single subwoofer, then this is the total peak power handling for all of the subs combined.
Peak power handling refers to the amount of power a speaker can handle during a brief musical burst. The RMS power range figure is a much more reliable rating for determining the speaker's power requirements.
Efficiency (1w/1m) is not an accurate indicator of a subwoofer's output capability and should not be used as a comparison to other speakers or subwoofers to determine which one is "louder".
Sealed - Sealed boxes are those that have no holes or vents in it. The only hole in a sealed box is where the subwoofer is installed. Smaller sealed boxes require more power than a larger sealed box. They provide a tight, accurate bass, while the larger sealed enclosures provide a "boomier" and louder bass.
Ported / Vented - Ported/Vented Enclosures provide an even boomier, louder bass, but less accurate then a small, sealed box. Ported enclosures typically require more airspace per sub and also less power output from an amplifier to perform correctly.
Bandpass - Bandpass enclosures make subwoofers perform efficiently, but loose. The bass is not as "boomy" as a ported enclosure nor as punchy as a sealed enclosure. Bandpass enclosures work well with lower to mid-level subwoofers.
Binding post terminals are a sturdier, more versatile type of speaker terminal. Because binding post terminals are are threaded, you can tighten them down against the wire or connector for a tight, clean connection. The most popular style of binding post terminals is known as a "5-way binding post". This type can accept bare wire, or any of the common speaker wire connectors. Binding posts with the option to be used with banana clips are even more versatile
Spring posts are a hybrid of the two. Instead of using a thread and "screwing" them tight, they use a spring to allow the wire to fit and tighten against the terminal.
Warranty and Return Policy
25 ft. of True 12 Gauge EnvyFlex Speaker Cable/Wire (100% Oxygen-Free Copper)
Your Price $39.99
Universal, Professional Heavy Duty Roller for Sound Damping/Dampening
Your Price $7.99
Internal Product ID
Wiring Diagram Legend
Warning: The image depicted shows the resistance change when wiring multiple subwoofer terminals. Please refer to your subwoofer's owner's manual for the proper wiring of its terminals. Sonic Electronix, Inc. is not responsible for damage caused to your audio system or vehicle due to improper installation. Please call tech support at 1-877-289-7664 if you require additional assistance.
Product Name: Kicker VS12L34 (11VS12L34)
The Sonic Advantage
What gives Sonic the edge over the competition
Fast & Free Shipping
Low Price Guarantee
60-Day Money-Back Guarantee
Free Lifetime Tech Support
Returns Made Easy
60-Day Money-Back Guarantee
No Restocking Fees
That's right, 100% refund on complete, like new returns. Learn More
Let's face it, electronics break. We've got you covered for a full year. Learn More
Easy Return Shipping
Request a return, use our shipping label, and ship it back. Learn More
Always available to answer your questions
Our trained install professionals can tackle any install challenge