Garage
Shop

Crown Audio XLS 2500

2400W, 2 Channel DriveCore Stereo Power Amplifier

Crown
Shop all Crown
highlight-star-icon

XLS High Performance, Lightweight Class D Amplifier • 2400 Watts x 1 Chan @ 4 Ohms • 1200 Watts x 2 Chan @ 2 Ohms • PureBand™ Crossover System • Peakx Limiters • Electronically Balanced XLR Inputs

Learn more about the xls2500

We apologize

This item has been discontinued

Description


Crown brand icon

Authorized dealer

What An Achievement

Crown's XLS Series amplifiers define the standard for portable PA systems with unmatched performance, technology and affordability. Its advantageous flexibility includes multiple inputs so you can plug in anything and play anywhere, along with several system setup configurations. The integrated crossovers and switch-mode power supply produce superior sound, and Peakx™ limiters protect your speakers. Weighing less than 12 pounds, compared to 40 pounds for its competitors, it's much easier to set up and move from show to show. Simply put, the XLS is most reliable, versatile, efficient amp available today.

XLS Series with Integrated DriveCore™ Technology

The XLS Series of power amplifiers from Crown define the standard for live sound systems with unmatched performance, technology, and affordability.

This high-performance line consists of four models each providing enormous power and flexibility thanks to the integrated DriveCore™ Technology, PureBand™ Crossover System and Peakx™ limiters. And weighing in at only 10 lbs or less, they provide the ultimate in lightweight portability.

Integrated DriveCore™ Technology

Class D amplifiers are notable for extraordinarily high efficiency and being well suited for driving difficult reactive loads such as subwoofers. However, their performance can suffer impaired performance on marginal and unstable AC line supplies.

To overcome this obstacle, Crown engineers developed DriveCore™ Technology – a proprietary hybrid analog-digital integrated circuit (IC) developed with Texas Instruments that drives the "front end" of the Class D output stage. Over 60 years of Crown's design knowledge and experience went into the development of this technology resulting in truly remarkable benefits.

DriveCore™ Technology provides an extremely wide-tolerance with regards to sagging or "dirty" AC line conditions providing consistent performance without affecting audio quality. This means that your performance will not be compromised by fluctuating generator power or overloading by lighting rigs, backline gear, etc.

In addition, DriveCore™ Technology's patented feedback and PWM modulation circuits enable fast recovery on peak transients, accurate reproduction of low-level detail, and precise tracking of low-frequencies at high power levels for maximum subwoofer output.

Advanced Switched-Mode Power Supply

This advanced power supply is highly efficient and optimized for maximum power transfer from the AC line through the Class D output stage to the loudspeakers. A benefit to this is substantial weight reduction when compared to older 60Hz transformer-based power supplies. All four models in the line weigh 10 pounds or less with no compromise in performance. This makes the XLS Series the benchmark for high performance lightweight portability.

PureBand™ Crossover System:

The PureBand™ Crossover System in the XLS Series adds an enormous amount of flexibility and performance to any system. With this system, the crossover frequency is completely variable allowing the choice of any crossover point between 50Hz and 3kHz on 1/12 octave centers. The use of 4th order Linkwitz-Riley filters provides steep slopes for a seamless transition between high and low drivers. And with four crossover modes to choose from providing the ultimate in flexibility, all of your system needs are covered.

Peakx™ limiters

Peakx™ limiters provide the ultimate in performance and protection for your entire system. This advanced algorithm was specifically developed and tuned to work with this amplifier and power-supply to achieve higher SPL will less audible artifacts. This means less distortion, less shutdowns, and maximum safe power delivered to your speakers. The Peakx™ limiters can be easily turned on or off by channel right from the front panel eliminating the need to be digging around in the back of the dark rack.

General Features:
  • XLS High Performance, Lightweight Class D Amplifier
  • RMS Power Rating:
    • 8 ohms: 440 watts x 2 chan.
    • 4 ohms: 775 watts x 2 chan.
    • 2 ohm: 1200 watts x 2 chan.
    • Bridged, 8 ohms: 1550 watts x 1 chan.
    • Bridged, 4 ohms: 2400 watts x 1 chan.
  • Integrated PureBand™ Crossover System for better performance and control
  • Peakx Limiters provide maximum output while protecting your speakers
  • XLR, 1/4", RCA inputs provide outstanding flexibility
  • Efficient forced-air fans prevent excessive thermal buildup
  • Electronically balanced XLR inputs; touchproof binding post and Speakon® outputs
  • Precision detented level controls, power switch, power LED, and six LEDs which indicate signal, clip and fault for each channel
  • 1-year Manufacturer's warranty
Specifications:
  • Sensitivity (for full rated power at 4 ohms): 1.4 Vrms
  • Frequency Response (at 1 watt, 20 Hz - 20 kHz): +0 dB, –1 dB
  • Signal-to-Noise Ratio Rated as dBr to full rated 8Ω power output (A-Weighted):
    • XLS1000: > 97 dB
    • XLS1500, XLS2000, XLS2500: > 103 dB
  • Damping Factor (8 ohm) - 10 Hz to 400 Hz: > 200
  • Crosstalk (below rated 8Ω power):
    • At 1kHz: > 85dB
    • At 20kHz: >55dB
  • Input Impedance (nominal): 20 kΩ balanced, 10 kΩ unbalanced
  • Load Impedance:
    • 2 to 8 Ω per channel in Stereo
    • 4 to 8 Ω in Bridge Mono
  • AC Line Voltage and Frequency Configuration: 120 VAC 60 Hz
  • Ventilation: Flow-through ventilation from front to back
  • Cooling: Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation
  • Air Volume Requirements (per minute per unit): 80.15 ft³ (2.27 m³)
  • Integrated Processing:
    • PureBand™ Crossover System
    • Crossover Filter: Linkwitz-Riley 24dB per Octave
    • Crossover Frequency Range: 50 HZ - 3 kHz
    • Crossover Mode: Crossover (CH1=LPF, CH2=HPF), LowPass (both channels LPF), HighPass (both channels HPF), Bridge (LPF or HPF)
    • Peakx™ limiters: Channel independent clip limiter designed to provide maximum output while protecting your loudspeakers
  • Input/Output:
    • Input Connectors: XLR (one per channel), 1/4-Inch (one per channel), and RCA (one per channel). 1/4-Inch connectors can be used as loop-thrus to distribute signal to additional amplifiers
    • Output Connectors: Two 4-Pole Speakon® Output Connectors accept 2-pole or 4-pole Speakon® connectors. The top Speakon connector is wired for both channels so it can be used for bridgemono wiring or for stereo wiring of two speakers to a single Speakon connector
    • One pair of back-panel binding posts per channel; accepts banana plugs or bare wire. (European models do not accept banana plugs.)
  • Construction:
    • XLS1000/XLS1500: 8.12-Inch (20.62cm) depth
    • XLS2000/XLS2500: 10.35-Inch (26.29cm) depth
  • Dimensions:
    • EIA Standard 19-inch (48.3-cm) rack mount width (EIA RS-310-B), 3.5-inch (8.9-cm) height.
    • XLS 1000/1500: 7.7-inch (19.6-cm) depth.
    • XLS 2000/2500: 10.7-inch (27.2-cm) depth.
  • Net Weight, Shipping Weight:
    • XLS1000: 8.6 lb (3.9kg), 13.6 lb (6.2 kg)
    • XLS1500: 8.6 lb (3.9kg), 13.6 lb (6.2 kg)
    • XLS2000: 10.75 lb (4.9kg), 15.8 lb (7.1 kg)
    • XLS2500: 10.75 lb (4.9kg), 15.8 lb (7.1 kg)

Product history:

Crown XLS2500 thumbnail
(newest, current model)
Crown XTI6000 thumbnail
(previous model, replaced by Crown Audio XLS 2500)

Specifications & Details


Power Specifications
Number of Channels
2 Channels
Continuous Power @ 8 ohm
440 watts x 2 channel
Continuous Power @ 4 ohm
775 watts x 2 channel
Continuous Power @ 2 ohm
1200 watts x 2 channel
Continuous Power @ 8 ohm (Bridged)
1550 watts x 1 channel
Continuous Power @ 4 ohm (Bridged)
2400 watts x 1 channel
Total Continuous Power
2400 watts
Amplifier Specifications
Amplifier Class
D
Signal-to-Noise Ratio
103 dB
Frequency Response
20 - 20,000 Hz
Cooling Options
Cooling Fan
Inputs
1/4" TRS
RCA
XLR
Outputs
Binding Posts (Banana Clip Ready)
SpeakOn
Physical Specifications
Height
3-1/2"
Width
19"
Depth
10-3/4"
Weight (Pounds)
10-3/4 lbs
Rackmount Spaces
2U
Warranty and Return Policy
Parts Warranty Duration
1 year
Labor Warranty Duration
1 year
Warranty Provider
Manufacturer

Item Details


Manufacturer:

Model Number:

XLS2500

Weight:

10.80lbs

Internal SKU:

xls2500

Internal Product ID:

32395

Customer Ratings & Reviews



5 star
67%
4 star
33%
3 star
0%
2 star
0%
1 star
0%



Durability
4.7
Value
4.7
Features
4.7
Design
4.7
Usability
4.4

Customer Reviews

Sort by:

Loading...

Solid Powerful Amp!

Bought this amp to power a dual 18" driver sub and it does a terrific job. Measured my in room sub only response and this amp digs low with lots of slam on tap. It is whisper quiet and runs cool which is a big bonus especially for those that use their living room for home theater purposes.

By Mike on September 22, 2012

5

found this helpful.

so far so good.

I received a great price on the product and haven't had any issue since purchasing 6 months ago.

By morgan on August 28, 2012

5

found this helpful.

crown amps rock!!!!!

This amp looked really cool and has lots of power too!!! Got it in my home hooked up to 4 Sony Xplodes also have tripple tens and polk tsi200's this amp was real easy to hook up to my home audio system and worked killer shakes my whole block!!!! Thanks to Anthony at Sonix and a great deal!!! I would recomend to all and i will be back for more thunder soon. Maybe (2) more crowns at least 2000's for my fosgate 10's, cant wait. Thanks Sonic for giving me the Power!!!!

By Thor Odinsson on May 14, 2012

4

found this helpful.

Related Searches


XLS2500 small

Item added to your cart.

Price: $429.99

Save up to 10 different vehicles in your garage

Loading...
Identify your vehicle and submodel details
  • Owner’s manual
  • Vehicle’s insurance card
  • Vehicle registration
  • Vehicle produced after 2005: Inside driver’s side door
  • Vehicle produced before 2005: Rear passenger doorjamb, glove box, center console, or engine compartment
Car Info Side Door Icon
Vehicle Registration Icon
Vehicle Insurance Icon