4 AWG In Line Zero Noise ZN1 Series AGU Fuse Holder with Four-Stage Watertight System
• 4 AWG In Line ZN1 Series AFS Fuse Holder
• Four-Stage Watertight System
• Diamond Plate Finish
• Impact-Resistant Clear Housing
• Mounting Base Plate and Mounts Included
• Impact-Resistant Clear Housing
• Forged Brass Connections
Internal Product ID:
35446
Nice holder
This is a nice AGU fuse holder, but you need to be careful when installing the fuse, as the rubber grommets tend to want to be pushed out for the ends when you tighten the ends. If you take your time, it works good. Besides that, it's good quality.
23
found this helpful.Works Perfect
Great product, absolutely no disruption in power. Holds and seals the power wire nicely.
23
found this helpful.Great Price & Great Product!
I bought a few of these for installing a fused power wire near the car Battery in a couple of my rides. Streetwires makes great car installation products & this is no exception. Great Product & Great Price!!
21
found this helpful.Yes
this product is outstanding easy to install and I love it
21
found this helpful.good and cheap
good pieces. very affordable and get the job done while still holding a good name to them
i bought two. one has served me well the other for some reason doesnt let current go past one side. i tried different fuses and nothing. im not sure why this happened. but it was just one ive had the problem with. had to buy another fuse holder to replace it. the other one has worked perfectly though.
20
found this helpful.Good product!
I would reccommend this fuseholder. Seems to be of good quality and does what it is supposed to do.
21
found this helpful.Great buy!
I have two of these holders; one is for my mb quart 4 channel and the other is for my mb quart 1600.1. I have had them installed for about 2-3 weeks and have had no problems. I was a bit skeptical about the quality because of the price, but i have been reassured after actually installing and running them. Local shops wanted about $20 a piece for fuse holders, sonicelectronix pulled through again!
21
found this helpful.Good value
This is just what I needed. Works great. Comes with spacers/inserts for smaller gauge wire also
19
found this helpful.Nice holder
This is a nice AGU fuse holder. I had to be careful when Installing the fuse, as the rubber end grommets wanted to push out when you screw the ends on. With a little patience, it worked ok. I would buy it again
19
found this helpful.Great Value
It's durable, good built ,water proof, simple and cheap I recommend it.
18
found this helpful.Best selling similar products