Top Loading Gold Maxi Inline Fuse Holder with 4/8 Gauge Input & Output with Adapters
• Top Loading Gold Maxi Inline Fuse Holder
• 4/8 Gauge Input & Output Adapters
• Uniquely Designed Connecting Fasteners
• High Temperature Composite Terminal Base
• High Current Transfer Capability
Internal Product ID:
36236
Money well spent
It is a good spade fuse holder and the cheapest I could find. The metal will not bent or break and should make a solid connection. To things that could have been better are 1) the clear plastic cover comes off too easily and could get lost. This piece however is not needed for the fuse holder to work. 2) the mounting screw holes are too small and too close the the center making it impossible to use existing screws that may be on the fender or firewall. Overall it's a good part
8
found this helpful.Quick n Easy
I installed two of these in just a few minutes. Slipped in a 40 and an 80 amp fuse. They have been working fine. I haven't had any problems. I liked the good fit of the wires and they tighten right up.
5
found this helpful.Fast N Easy
I find these fuse holders to be very good at holding fuses. The wire goes right in and the set screws tighten them up just fine. Add a couple of self tapping screws to fasten it down. Then you just push in a fuse and it works. The other ones I bought are working fine so I got another. Will probably buy some more soon.
5
found this helpful.Fuse holder
How do you rate a fuse holder?
I does work and it does hold a fuse. A little sarcastic but accurate.
3
found this helpful.POOR FUSE CONTACTS!!!
wouldnt buy again, very poor contact surfaces for fuse, they get hot when passing current, crap!
4
found this helpful.Best selling similar products