400 watts, 2-Channel Amplifier
400 Watt 2 Channel Amplifier • 100W x 2 RMS @ 4 Ohms • 150W x 2 RMS @ 2 Ohms • 400W x 1 RMS @ 4 Ohms • Platinum Plated Screw Type RCA Jacks • Variable High Pass & Low Pass Filters • Stainless Steel Finish Heat sink • Full Mosfet Circuitry
Learn more about the hk298400 Watt 2 Channel Amplifier • 100W x 2 RMS @ 4 Ohms • 150W x 2 RMS @ 2 Ohms • 400W x 1 RMS @ 4 Ohms • Platinum Plated Screw Type RCA Jacks • Variable High Pass & Low Pass Filters • Stainless Steel Finish Heat sink • Full Mosfet Circuitry
Internal Product ID:
3677
Very Good Amp
I Have this hooked up to 1 MTX Thunder 5500 8" T5508-44 wired bridged in parallel for a 2ohm load putting 400watts. when the sub level is cranked up the sub hits pretty hard, but i haven't had much experience with 8"ers. I have the amp X-over putting the higher bass to the 8" while my 2 15"s take over the low end. Dollar for Dollar this is a very good amp. I Only use MA Audio amps Great Prices, very HIGH POWER, And very Reliable products.
1
found this helpful.I once had one of these amps it was good until the day it started to smoke and from then on it didnt work since it couldnt take both of my 12 inch MA audio subs..... this amp is good but just dont turn your music too high or you will end up overheating it...
2
found this helpful.Best selling similar products