Full Spec 4 Gauge 100% (OFC) Oxygen Free Copper Amplifier Power Wiring Kit with Speaker Wire for Amplifiers up to 1500 Watts
• 4 Gauge Power Amplifier Installation Kit
• For Amplifiers Up To 1500 Watts RMS
• 100% (OFC) Oxygen Free Copper
• Tinned conductors for corrosion resistance
• Pre-terminated seamless power and ground ring terminals
• ANL/Mini-ANL Fuse Holder with 100 amp fuse
• CEA-2015 and BC5W2 Compliant
• 4 Gauge Power Amplifier Installation Kit
• For Amplifiers Up To 1500 Watts RMS
• 100% (OFC) Oxygen Free Copper
• Tinned conductors for corrosion resistance
• Pre-terminated seamless power and ground ring terminals
• ANL/Mini-ANL Fuse Holder with 100 amp fuse
• CEA-2015 and BC5W2 Compliant
Internal Product ID:
45061
Great value for money!
From the braided to the thick true gauge OFC cable, this is a good amp kit, going to trust NVX after all this amazing kit.
119
found this helpful.Great Amp Kit
I have been buying and installing car audio for about 18 years and out of all those years I have to come across an amp kit like this. This is the best kit I have ever installed. The wire is true to gauge ofc. I installed it in my car without any problems. Very flexible easy to work with. If you want a good amp kit don't buy this one but if you want a great amp kit purchase this one.
118
found this helpful.Great cables top quailty
hard to bet silver tinned copper cables even the speaker wire it comes with is silver tinned
120
found this helpful.Super Product
Very nice product. The quality of the power and ground 4 gauge wire was great. Already had one end prepped with a terminal and the power wire has a protective sleeve for about 4 feet. The only complaint I have is that the plastic cover that goes over the fuse holder doesn't snap very tight, easy to knock off and expose the fuse. I put electrical tape down both sides to help hold it on.
103
found this helpful.Quality Kit
I bought this kit because it is high quality, uses true 4 gauge wire, and comes with 20ft. of power wire. It is working very well with my JAD1200.1 amp. I get about 0.5V of voltage drop at full power, 1 ohm impedance on test tones. I am very happy with the performance of this wire.
107
found this helpful.Great Amp Kit
High quality amp kit . Everything u need and more to hook up a single amp. Great value also for what is included in kit.
104
found this helpful.Great Product
This sound deadener is great the best I have ever used. It is very thick and sticks to anything. I used it on my rear speaker deck cover. I didn't know if it would stick do to the that the cover was made of fiberglass. It worked, stuck to the cover like glue. The only down side to the product is like any the black tar like substance if you get it on your hands or fingers have to use paint thinner to remove, other than that the product sticks to just about anything. The price is great too, dynamat for the same about cost about 3 times as much. The NVX is a much superior product than dynamat also not paying to fill chip foose back pocket.
102
found this helpful.I'm addicted to NVX!
I used this in my 2008 Town & Country too! I purchased this kit to power my NVX JAD900.5 and could not be more pleased! Good quality, thick, durable, flexible... the list goes on! This made my install so easy! I can find only one problem... I don't have enough vehicles to do installs!! I can't get enough of NVX! I would be happy installing NVX on a daily basis! Everything NVX is fun and easy to use!! Thanks guys... you ROCK!
102
found this helpful.Good price Great quality
pros: easy to maneuver, tons of cable, good price, true 4 gauge
cons: the inline fuse holder is a bit tricky to wire in, also don't provide an allen key to tighten it.
102
found this helpful.GREAT PRODUCT!!!!!
I bought this kit to go with my rockford fosgate amp, it gets the job done!!!!! Very happy with this purchase!!!!! I will be buying another one for my second car this spring!!!!!
101
found this helpful.Best selling similar products