Hifonics Brutus BRX1100.1D
1100 Watt RMS Brutus Series NextGen Class D 1-Ohm Stable Monoblock Subwoofer Amplifier - (Brutus 1100 Watt)
Quantity: 1
General Features:
- Brutus Series Monoblock Class NextGen Super-D Car Amplifier
- RMS Power Rating (@ 14.4V):
- 4 ohms: 450 watts x 1 chan.
- 2 ohms: 800 watts x 1 chan.
- 1 ohm: 1100 watts x 1 chan.
- Ultra-Fi MOSFETS Circuit maximizing power efficiency while improving sound quality
- Heavy duty aluminum alloy heat-sink with illuminated Hifonics logo
- Lighted connectors and blue wash of light from the underside of the heatsink
- LED power (green) and protect (red) indicators
- Wired remote bass level control included
- Built-in system diagnostics
- 1-Ohm Stable operation
- 10 AWG speaker output connections
- Dual speaker terminals simplify the hookup of multiple speakers
- Full-range Preamp RCA outputs to daisy chain multiple amps
Full-range only if a full range signal is connected to input - 3-way protection circuitry (thermal, overload, and speaker short protection)
- Master/Slave Mode with Output/Input Switch and Dedicated RCA connections
- Input sensitivity: 200mV - 9V
- Variable low-pass filter: 35 - 250 Hz
- Variable sub-sonic filter: 15 - 35 Hz
- Variable Bass Boost (Bass EQ): 0 - +10 dB at 45Hz
- Frequency response: 10 - 250 Hz
- Damping factor: >200
- Signal-to-noise Ratio: >95dB
- Total harmonic distortion: 0.10%
- Fuse Rating: 60A x 1
Design may vary from picture on website - CEA-2006 compliant amplifier
Confirmed by Manufacturer - Dimensions: 14-3/8"L x 10-5/16"W x 2-1/2"H
- Authorized Internet Dealer
- 1-year Manufacturer's Warranty
Check out the Hifonics BRX1100.1D Owner's Manual
XS Power XP750-CK
XP750 AGM Battery Power Cell + Installation Kit for 1000-1500 Watt Audio Systems
Quantity: 1
- (1)XS Power XP750 Battery
- (1) Battery Holder
- (1) 18 ft. 4 Gauge XP FLEX BL Cable
- (1) 3 ft. 4 Gauge XP FLEX Ground Cable
- (6) XS Power Brand Heat Shrink
- (6) 4 Gauge Crimp Terminals
- (2) Battery Clamps
- (2) Grommets
- (2) Fuse Holder, ANL, Set Screws
- (2) Fuse, ANL, 200A
- (10) Wire Clamps
- (10) Zip Ties
- (10) Screws
Wiring Features:
- All-in One Battery plus Battery Wiring Kit
- Designed for 600-800 watt audio systems
- 4 gauge Pre Ring terminated power and ground wire with protective heat shrink wrap
- Thick but flexible CCA Copper-Clad Aluminum wiring
- XP FLEX Frosted Black ground wire
- XP FLEX Frosted Blue ground wire
- Complies with American Wire Gauge (AWG) standards
- Authorized Internet Dealer
- 1-year Manufacturer's Warranty
- A Battery Isolator is STRONGLY recommended when installing a second battery:
- Prevents secondary battery from draining the starting battery
- Big 3 Upgrade Kits:
- To get the most out of your new power system check out our Big Three Upgrade Kits
Battery Features
- 12-Volt Deep Cycle AGM Power Cell
- Sealed absorbed glass mat (AGM) design
- Designed for use as an additional battery to power your high-performance sound system
- Leak-Proof, non-hazardous design
- Stores energy so you don't need a capacitor for your system
- No external vents allow this battery to be mounted in any position with no leaks
- Resists extreme vibrations for ultimate performance
- 100% Sealed and maintenance free
- M6 Terminal hardware included
- XS Power 580 terminal post adapters available
- Authorized Internet Dealer
- 2-year Manufacturer's warranty
- Cranking Amps: 750
- Maximum Output: 750 Amps
- Amp Hours: 22
- Weight: 14.5 lbs
- Dimensions: 7-1/8”L x 3-1/16”W x 6-3/4”H
Note: This battery is intended to be used as an auxiliary battery (trunk or marine applications). Not intended for under the hood or extreme heat.
Check out the XS Power XP750-CK Installation Procedure