300W Max, 2-Channel Amplifier
2-Channel Class AB Car Amplifier • 50W x 2 chan. @ 4 ohms • 75W x 2 chan. @ 4 ohms • PWM MOSFET Power supply • Tuned Bass EQ (0-12 dB bass boost) • Speaker short circuit protection • Extruded aluminum heatsink
Learn more about the pba21502-Channel Class AB Car Amplifier • 50W x 2 chan. @ 4 ohms • 75W x 2 chan. @ 4 ohms • PWM MOSFET Power supply • Tuned Bass EQ (0-12 dB bass boost) • Speaker short circuit protection • Extruded aluminum heatsink
Internal Product ID:
12396
Good for me!!!
Needed an amp for one sub (KICKER 07C104) the rep told me about this product and up till now am very satisfied with it lifts my sub just enough for the car or i can pump it up to let the neighbours now i am home.
6
found this helpful.Not bad for 2 channels
Would recommend this AMP for its size and if you only have 2 speakers in the vehicle.
Used it to boost the speaker sound bar in my 2002 Jeep Wrangler.
Because of its size, I was able to put it under the drivers seat with no issues.
6
found this helpful.Great amp
this amp is great for subs for 150 rms subs it sounds great it's an amazing amp and has a 12db bass boost and has never over heated when i cranked it all the way
4
found this helpful.Like it alot!
I bought this unit to fit under the drivers seat of my 2002 Jeep Wrangler. I was right it fits great!
Took out the seat for installation, but was worth it. Gives my sound bar the needed punch to get the sound up to a listenable level with all the road noise that a Jeep has. Wired power to Amp on left side of Jeep separate from the Speaker wires witch I brought in from the right side. No noise or hum in the system at all.
I purchased this along with the wire kit and a DUAL radio. Love it so far.
JEEP's RULE!!!!!!!
4
found this helpful.Pretty Awesome
I have a single Kicker Comp 10 sub woofer. 300Watts 150 RMS. This amp does an amazing job driving the sub. I picked it mainly because it had the same power as the sub did, so I didn't have to worry about blowing the sub. The amp is small so it fits well under my back seat. It was very simple to setup and install as well as to use. You need to have some idea on how to install it because you have to run a fused line to the battery, a line to the ACC, and a ground line. But for a mono channel amp, it is quite phenomenal with my sub woofer.
1
found this helpful.Best selling similar products