1/0 Gauge Interlok Power Ring
1/0 Gauge Interlok Power Ring • Maintains gas-tight contact with every strand of wire • Machined wrench flats allow easy tightening
Learn more about the pri0Streetwires can help you power and connect your entire system. These inter-lok ring terminals are setting the standard for power rings!
Internal Product ID:
15895
The best you can ever buy!
Most of these ring terminals only have a single screw that holds the copper into the housing, but not this one. It has a 2-part housing where you spread the wire over the inside part and it screws securely into the outside housing. Makes an incredibly strong connection that cannot come undone. I used on battery terminals and alternator. Only issue I had was that the ring terminals are very thick. I had to grind the one used on the alternator a little to get the screw on it.
13
found this helpful.Boo Streetwires, not the quality they once were.
Don't buy these. They look great but that is about it. These cable ends are not capable of holding their shape under the torque required to assemble them. "What are you talking about?" When you place a properly sized hex wrench on the hexed piece of the cable end it flexes and deforms when you get it at just about tight enough to hold the wire in the assembly. They would never be reusable as they should be, one time assembly only if you are lucky.
11
found this helpful.Streetwires PRI0
I had ordered several sets of these. The last batch was mixed. Street wires for the worse changed the design. I'm assuming it was cheaper and that's the reason. Streetwires was once a respectable name. Now Mitek doesn't care and it clearly shows.
If you are just ordering these for the first time, you shouldn't notice much difference then what the picture shows. The new ones are squared off and look like crap. The pics are rounded and look good
12
found this helpful.StreetWires PRI0 Review
These work great and also fit 4/0 AWG wire with some cutting to the 0000 AWG wire.
11
found this helpful.Best selling similar products