1600W Max, Punch Series 4-Channel Amplifier
4-ohm stable in bridged mode • Tri-way capable • MOSFET power supplies and output stages • MEHSA transfers heat efficiently from the MOSFET devices to the heat sink for high performance • TOPAZ eliminates ground loop noise • trans-ANA circuitry keeps preamp signal clean • preamp outputs • variable high-pass/low-pass crossover (40-400 Hz, 12 dB/octave) • variable Punch Bass boost (0-18 dB at 45 Hz) with remote
Learn more about the p40044-ohm stable in bridged mode • Tri-way capable • MOSFET power supplies and output stages • MEHSA transfers heat efficiently from the MOSFET devices to the heat sink for high performance • TOPAZ eliminates ground loop noise • trans-ANA circuitry keeps preamp signal clean • preamp outputs • variable high-pass/low-pass crossover (40-400 Hz, 12 dB/octave) • variable Punch Bass boost (0-18 dB at 45 Hz) with remote
Internal Product ID:
2203
Great Amp and Performance
I actually found this amp online used for a budget build and only paid $50. Well I can't be any happier because this amp is solid. I have used it in 3 channel mode powering 2 front speakers off front channels and one 10" Punch P2 @ 4ohm from the rear channels bridged. I recently moved my rear deck speakers to the floor of my front seat and have them bridged at 2 ohms!! It never has cut out and I always have my music as loud as my head unit will allow and the quality of the sound, in my opinion, doesn't drop one bit. Of course, it's not recommended but if you know RF then you know they are made to do more than you expect. This amp has been discontinued for a while but if you find this amp used and pretty cheap, hop on the deal.
20
found this helpful.Best selling similar products