Gold ANL Inline Fuse Holder with 0/2 Gauge Input & Output with Adapters
• Gold ANL Inline Fuse Holder
• 0/2 Gauge Input & Output Adapters
• Uniquely Designed Connecting Fasteners
• High Temperature Composite Terminal Base
• High Current Transfer Capability
Internal Product ID:
36244
Cheap by adequate
I purchased 3 of these and my review is based on average product quality.
It's about what I expected from Xscorpion, a low price point for a usable piece of equipment. Machining is sub-par, lots of burrs, screw thread tolerances are loose and I'm a little nervous about stripping them. I wasn't particularly thrilled about the exposed bolt heads on the bottom of the casing, even though they're recessed it could pose a potential problem. Plastic casing seems to be made pretty well.
Quality control is pretty poor considering significant variation between the three. However, all the holes are where they should be and it does it's job. This fuse holder is designed for 2/0 wire and can accommodate smaller 1/0 with the included reducer rings which is a tight fit with true spec wire. I wouldn't recommend using it with anything smaller than 1/0.
Conclusion:
If you're on a budget, this fuse holder will do just fine. Remember that it's cheap for a reason, you get what you pay for.
5
found this helpful.Xscorpion ANL02G
use under the hood 0 awg in/out low cost and works as it states, fitting keep wire snug
6
found this helpful.Works
Nice quality and fits 1/0 wire nicely. I would recommend this fuse holder.
Best selling similar products