600W 6-Channel Class D M-Series Marine Amplifier
• RMS: 75 W x 6 @ 4 ohms, 100 W x 6 @ 2 ohms, 200 W x 3 @ 4 ohms Bridged
• NexD™ Switching Technology
• Advanced Rollback Protection
• Frequency Response: 12 Hz - 22 kHz (+0, -1dB)
• Detented, Calibrated Filter Freq. Potentiometer
• RMS: 75 W x 6 @ 4 ohms, 100 W x 6 @ 2 ohms, 200 W x 3 @ 4 ohms Bridged
• NexD™ Switching Technology
• Advanced Rollback Protection
• Frequency Response: 12 Hz - 22 kHz (+0, -1dB)
• Detented, Calibrated Filter Freq. Potentiometer
This potent 6-Channel amplifier employs JL Audio's high-speed NexD switching design to achieve unprecedented efficiency and amazing power output in an ultra-compact chassis. Don't let the small size fool you, though... this amplifier is capable of serious power, delivering a full 600W of continuous total power into a 2 ohm load (14.4V, 1% THD). Targeted specifically for an audiophile-grade system, the M600/6v2 includes a variable mode low-pass/high-pass filter with a continuously variable cutoff frequency selection from 50-500 Hz. With the M600/6, you have lots of great options. Use it as a six-channel satellite amplifier with 75 W x 6 @ 4 ohm , or bridge four of its channels to create a staggered power four-channel amplifier with 200 W x 2 @ 4 ohm for your front satellites and 75 W x 2 @ 4 ohm for your rear satellites. You can also drive two subwoofers with 200 W each, plus a pair of satellites with 75W x 2.
With the addition of an HD-RLC remote level control (sold separately), you can control the volume of one, two or all three channel pairs of the M600/6v2 from the front of the vehicle or boat. This amplifier features white and gray powder-coat finishes, a gasketed cover for the controls and stainless steel hardware for durability in the marine environment.
JL Audio's signature Advanced Thermal Rollback protection system eliminates annoying thermal shutdown events to keep the music playing, even under the most demanding conditions. Should the amplifier reach an unsafe operating temperature, a special circuit rolls back peak power output, without changing gain, until the amplifier cools down to a safe operating temperature. The red "Thermal" LED will light to indicate this condition has been reached. Once the amplifier cools down, the circuit restores full peak power output and the red "Thermal" indicator reverts to its normal state. The operation of Advanced Rollback Protection is inaudible in most cases.
From the same minds that gave us the technology found in the 'Slash' amplifiers, JL Audio has taken the simple fixed PWM design approach and enhanced it with a very high switching frequency. Full-range NexD amplifiers and channels feature a variable, ultra-high speed version of the NexD technology (switching at well over 400 kHz). In these designs, a self-oscillating modulator with "feed-forward" sends information about the instantaneous power supply voltage to the modulator, combining this with the input signal to cancel out any distortion due to supply voltage fluctuation. This reduces distortion prior to applying feedback, simplifying the overall feedback loop design.
Internal Product ID:
39851
Awesome amp!
I have this amp on 12 speakers in my wakeboard boat. (10) Polk mm's 6x9"' and (2) 6.5" Polk mm's. Pushes all 12 speakers great and crystal clear. Will wake the dead. Very pleased with this amp and I run it hard for hours at a time with no problems.
18
found this helpful.Best selling similar products