15" VCW152 VC Series Subwoofer + Class D Monoblock BB Series Amplifier
• Peak Power: 2000W
• RMS Power: 1200W
• Pressed Paper Cone With Woven Fiber Top
• High Excursion Foam Surround
• Class D Circuitry
• Bass Boost 0-12 dB at 30-80 Hz
• Peak Power: 2000W
• RMS Power: 1200W
• Pressed Paper Cone With Woven Fiber Top
• High Excursion Foam Surround
• Class D Circuitry
• Bass Boost 0-12 dB at 30-80 Hz
NVX VCW152 Version 3 (VCW152v3)
3000 Watt Peak (1500W RMS) 15" VC-Series v3 Dual 2-Ohm Car Subwoofer
Quantity: 1
Internal Product ID:
76085
So far so good.
I needed a new amp to power my AudioPipe BD3 12, it was on a 2channel Oxygen Audio amp that only did 600w @ 2ohms. The best it could do was 1200rms bridged @ 4ohms. Anyway, I needed a "budget" amp that could push some more power. I have it wired to 2ohms and it sounds noticeably better. I've only had it for a dew days so I can't speak for longevity, but price for power rationis definitely on point.
The only bad thing I can speak on so far is the bass remote. The minute I plugged it in I got a loud feedback and noise from my sub and it froze. Idk whatn the hell that was about, but I just stayed with the bass remote from my active xover. Because of very mixed reviews In was sure to buy the warranty plan for this amp. Rather be safe than sorry.
60
found this helpful.Just as advertised !!!
I have this hooked up to a Hifonics 1100.1 d Brutus amp pushing 1000 rms and it beats the block hard!! Hits incredible lows and all around great sound! Great price and fast shipping sonic is the best!!!!
51
found this helpful.Amazing Subwoofer
Has a very good feel and structure very solid. Large cone area much better than average stitching and craftsmanship. Mine sounded amazing squeezed the trunk of a VW Golf but you will be heard, Make sure you give it accurate power because of that new motor rating wattage requirements I had mine going for 7 months at around 1200 watts and finally the voice coil was shot.
53
found this helpful.not quite 2000 rms
Wired to 1 ohm on the scope I can see more like 1300 before this amp clips. Overall totally worth the money sound is clean have not put it in protect yet nor cooked it. Right now its pushing a pair of infinity 12s hard enough to flex every panel in the car including the hood. Would like another one for my truck due to its small size. Too bad it doesnt take bigger than 4ga wire....
60
found this helpful.Amazing Deal! So Far So Good
I bought this sub to install in a friend's car. I bought it with the free ported sub box deal for a fantastic price (Although it didnt fit in the box so I had to sand it down by about 1/2") Regardless this thing suggests about 900 Watts RMS in a ported box (I ran it off of a Rockford Fosgate 750-1D). Sound clarity is amazing and it gets some seriously crushing lows. Its almost as loud as my 2 15" Kicker CVR's in just one woofer! Overall great sub, i would definitely recommend it!
52
found this helpful.Holy moly!
Wowzers, I purchased an open box version and when it arrived I was stunned at the build quality. I researched this amp extensively before purchasing, clamp videos and forums, I STILL didn't expect such superb quality from an amplifier so inexpensive.
On par with $300 amplifiers such as Sundown,DC,Crescendo etc... etc... but at a fraction of the cost. Now obviously this isn't a $300 amplifier so it isn't going to put out much more than rated RMS, but considering it is CEA-2006 certified and has a few clamped/O-scoped videos on youtube doing approx rated power its pretty darn good.
Sucker is heavy compared to "mainstream" amps like Kicker,Pioneer,Sony. Bass remote is excellent quality as well, even the remote CORD is high quality.
One of the secondary reasons for picking this amplifier was the Bass boost EQ (30-80hz adjustable), no other amplifiers in this price range have it, Unless you want to spend $250+.
It was a tough decision between this and the Hifonics line of CEA-2006 models. I'm very content with my choice.
56
found this helpful.Best Cheap amp
This in my opinion is the best of the amps...It will definitely flex stuff if you have the right sub and box combo!!!
54
found this helpful.I guess it works?
Bought this amp to power my Audiopipe BD3-12 and a week in, my sub is dead. The amp definitely powered it better than the OxygenAudio amp that was only doing 600w RMS @2ohms. Its wired with 4 guage Ground and P+. I went through the whole tuning with a 50hz wave and set my gains with a DMM at 41volts (which is from my math of 900wX2Ohms=1800, SqaureRoot of that being 42.xxx). I really hope that I didn't leave any space for clipping, but there is definitely a dead coil in my sub as I can feel some scraping when I push in the cone. I guess I dont know if I should be happy that the amp apparently has some power, or sad and confused that my sub is dead and it could possibly have been my fault...
Amp is very plain, sorry if im used to some sort of illumination from my previous O2 and Alpine amps, but I guess simplicity works. I would have loved an illuminated face on it. IJS.
54
found this helpful.Sounds Great!!!
I had never heard of this amp and I have been building custom stereo systems for over 20 years and this amp sounds awesome for the money. If your looking to build a nice system and keep money in your pocket I suggest this brand of amp for your subs.
53
found this helpful.belva bb200
I have this amp pushing to American bass xd 10's! Plenty of power it doesn't even get hot.
54
found this helpful.Best selling similar products