NVX Power Distribution Blocks at Sonic Electronix

NVX Power Distribution Blocks

For the best power transfer possible, be sure to use NVX power distribution blocks.
Filters
Loading...
Filters
This specifies what the intended use of the distribution block is. Fused distribution blocks are intended to be used with the power wire and the fuse acts as a short-circuit or surge protection so your amplifier is not as likely to be damaged. Non-fused distribution blocks can used with ground or power wire connections, but the protection on power wire connections will not be present as there is no fuse in the distribution block. Therefore, we recommend your amplifier has an external fuse for short-circuit or surge protection. When using either type of distribution block, it is recommended to use a main fuse holder within 18 inches of the battery.
For accessories, this is the type of fuse that is required for the item to work properly.

For fuses, this is the type of fuse.

This is the number of fuses that the item requires to work properly.
This is the total number of input connections that go into the unit.
This is the largest gauge wire that will fit into the power and ground terminals of this device. The lower the gauge number, the thicker the wire is. For example, a 4 gauge wire is thicker than an 8 gauge wire and thus has higher current carrying capacity. Always do your best to get this size wire to reduce the risk of damage to your components.
This is the total number of output connections that the unit will produce.
This number refers to the maximum size of wire that will fit into the output connector(s) of the capacitor, battery terminal, or any other connector with an wire output.
listview icon
gridview icon
NVX XFDBU2

2 Position Fused Distribution Block with One 0/1 Gauge Input and two 4/8 Gauge Outputs

XFDBU2 main
Go to item page

2 Position Fused Distribution Block with One 0/1 Gauge Input and two 4/8 Gauge Outputs

• One 1/0 Gauge Input
• Two 4 Gauge or 8 Gauge Output
• Satin Chrome Plated Terminals
• All Brass Hardware

25
NVX XFDBU2

2 Position Fused Distribution Block with One 0/1 Gauge Input and two 4/8 Gauge Outputs

In stock

 
$19.99

Item Added to Cart

XFDBU2 small

2 Position Fused Distribution Block with One 0/1 Gauge Input and two 4/8 Gauge Outputs

$19.99

Keep Shopping

T-Spec V8-MANL40

V8 Series 40A Nickel Plated MANL Fuses

$3.00

Add

Don't see the accessory you're looking for?
View all available accessories for the NVX XFDBU2.

NVX Power Distribution Blocks Information

NVX power distribution blocks provide a wide array of power and grounding applications. Built with solid brass and chrome plating, you are sure to transfer the best power possible. Get extreme current flow with NVX power distribution blocks.
    clear all items