Access exclusive offers, news and more.
1,200W Peak (600W RMS) 10” L7S Series Solo-Baric Dual 2 Ohm Square Subwoofer
• Peak Power: 1,200 watts
• RMS Power: 600 watts
• Injection Molded Polypropylene - IMPP Cone
• Santoprene Rubber Surround
• Impedance: Dual 2 ohms
• Mount depth: 6-1/4"
• Sensitivity: 85.87 dB
Choose from any of our many bundles that include this product for even more savings!
Kicker L7S102 with Ported Enclosure
1,200W Peak (600W RMS) 10" Dual 2-Ohm
Save 20% when you add an Atrend 10SQKV Vented Subwoofer Enclosure to your Subwoofer purchase. Simply click the "Add Both to Cart" button. This offer cannot be combined with any other coupons or offers.
Priced separately $323 95
Promo Savings of $20 00
Internal Product ID:
I didn't think needed a 2nd sub but wanted better mid bass this is the few sub that goes over 250hz. It's paired with an Alpine R 12 so I can switch back and compare. It's in a portend box made for it. Sonic had the package around $300 not bad. Getting a box made for the speaker was the deal maker. Closed may have been better for size but nice to try a ported. This is the only speaker I would ever consider from Kicker. Earth shattering maybe not. I'm not pushing it too hard. Tight and crisp maybe not in the ported box but nice enrichment yes. Could be your only sub and you would be happy.
6found this helpful.
I love these subs hit hard I always buy kickers for subs
4found this helpful.
2 Little Monsters
I have two of these in 1.24 cu ft per sub box in a regular cab truck powered by a RF 1000.1bdcp. There getting 1550 watts rms. These subs and the RF amp are a monster combo!
Best selling similar products
• 800W Max
• 200W RMS
• Poly-Coated Paper Cone
• Foamed Rubber Surround
• Stamped Steel Shallow Mount Basket
• Vented Motor Structure
• Dual 2" 4-Layer Voice Coils
• 300 Watts RMS
• Sensitivity: 84.07 dB
• Mineral-Filled Polypropylene Cone
• Large Roll Surround
• Elevated Frame Cooling
• DMA Optimized Motor System
• Metallic Silver Frame Finish
• Mounting depth: 3.250 "
• Precision-built in USA at JL Audio’s Miramar, Florida factory
• Injection molded, mica-filled polypropylene cone
• Rubber Surround
• Cast Alloy Basket
• DMA-optimized motor design
• Very small sealed enclosure volume requirements
Warning: The image depicted shows the resistance change when wiring multiple subwoofer terminals. Please refer to your subwoofer's owner's manual for the proper wiring of its terminals. Sonic Electronix, Inc. is not responsible for damage caused to your audio system or vehicle due to improper installation. Please call tech support at 1-877-289-7664 if you require additional assistance.
Save up to 10 different vehicles in your garage