300W Max (150W RMS) 8" Punch Stage 3 Shallow Mount Dual 2-ohm Subwoofer
• 300W Peak
• 150W RMS
• Dual 2-Ohm Voice Coil
• Anodized Aluminum Cone And Dustcap
• M-Roll Santoprene Surround
• Stamp-Cast Basket
• Dual Linear Spiders
• 300W Peak
• 150W RMS
• Dual 2-Ohm Voice Coil
• Anodized Aluminum Cone And Dustcap
• M-Roll Santoprene Surround
• Stamp-Cast Basket
• Dual Linear Spiders
Sonic Electronix is now carrying the brand new line of Rockford Fosgate Punch P3 Series Car Audio Subwoofers. The P3SD2-8 Punch Series 8" Subwoofer has a peak power rating of 300 watts and a RMS rating of 150 watts. This sub will produce some earth shaking bass and is constructed with an anodized aluminum cone and a vertical attach surround technique. This woofer is also equipped with a 2" Voice coil and a protective PVC textured magnet cover. Add some bumps in your trunk and enhance your cars stereo system with this Rockford Fosgate Punch Series Subwoofer.
While built on a long standing history of performance, the punch series woofers can deliver not only the output to satisfy you when you want it loud but maintain a level of sound quality for when you really want to "listen" to your music. Taking many design cues from the Power Series, Rockford Fosgate engineers continue to improve the Punch Series year after year making it one of the most sought after woofer lines for music and bass enthusiasts alike. With features like Dual tear & fatigue resistant poly-cotton spider for high strength and anodized aluminum voice coil formers to handle heat buildup in the motor structure under full power situations, these drivers are designed to perform.
Anodized Aluminum Voice Coil Former
By using an anodized aluminum voice coil former on their subwoofers, Rockford Fosgate is able to dissipate heat from the voice coil more efficiently. A hot voice coil can melt the adhesive bonds, which will lead to eventual subwoofer failure. The aluminum voice coil former acts as a heat-sink to dissipate thermal build-up on the voice coil cool during high SPL conditions.
Conforms to CEA-2031
Rockford Fosgate has built this subwoofer to conform to the CEA-2031 loudspeaker power handling industry standards. This means that you can trust the subwoofer to have the capacity to safely handle the continuous (RMS) power rating. Having a CEA-2031 power handling is important when matching a subwoofer to an amplifier because the power ratings are accurate.
Stitched Tinsel Leads
To improve the reliability and performance by reducing fatigue and possible shorting, Rockford Fosgate has stitched the tinsel leads to the spider. The multipoint periodic stitching lead wires reduce the mass of the tinsel leads to spread the stress over a greater area. This improves the reliability and performance of the subwoofer.
VAST: Vertical Attach Surround Technique
In order to increase the surface area of the cone without causing any installation issues, Rockford Fosgate designed the Vertical Attach Surround Technique (VAST). By redesigning the manner in which the surround adheres to the basket, these speakers gain up to 25% more effective radiating cone area. This improves the nominal efficiency and maximum output.
![]() |
![]() |
Priced Individually
Internal Product ID:
43412
Great sound!
These sound fantastic for a shallow sub. I put these in the door of my 2012 Mustang and due to the duel coil overs I was able to wire them in a way that matched my stack amp. It sound awesome now.
24
found this helpful.un peu faible !!!
je viens d'acheter se 8 " rockford , 150 WATTS R.M.S , je le trouve un peu limité en puissance je vais le remplacer par un kicker compact RT 10" 1 ohms 600 watts R.M.S !!!
20
found this helpful.Installed in 2004 4Runner with JBL system
Sounds great! Fit the factory box very well. I used the beauty ring, but not the grille (used the factor grille), and the beauty ring centered the sub in the box opening perfectly. The bass is nice and tight, and not overdriven.
19
found this helpful.Great Stock upgrade
Installed in 2002 Suburban 1500 with factory sub non Bose system. This speaker is a little small in diameter for the factory box. 8.5inch woofer may fit stock enclosure better, however the sound quality is greatly improved over the stock speaker and 8.5" speakers are very limited selection. The shallow design fits anywhere and for a very reasonable price.
20
found this helpful.Great bang for the buck.
I put these in the door of my 2012 Mustang and due to the duel coil overs I was able to wire them in a way that matched my stack amp. It sounds awesome now.
17
found this helpful.Exceptional performance and quality!
I am absolutely satisfied with this woofer, its a "punch" in a tiny package, used this on a 02 Frontier with the stock RF Punch Series setup, i replaced this woofer first and from the get go it was aspiring, thanks sonic electronix for the great value/quality/affordability you bring to sound system enthusiast. \m/ Hailz From SoCal, Keep The Metal Faith Alive \ m /
15
found this helpful.Nice added bass to a factory setup.
Installed this in a Colorado crew crab in a custom sealed box at .4 cu ft. under the rear seat. Paired it with a Rockford Fosgate Prime R125-2 wired at 4 ohms. To be honest this wiring configuration did not sound good. Sounded hollow or poppy to try and describe it. I switched to one channel and wired at 2 ohms using just the single voice coil. Major improvement wired this way.
4
found this helpful.replaced oem gone bad
Speaked was recommended for fit in existing opening in wifes 07 4runner without replacing stock amp and fit great. Screw holes didnt all line up but no big deal. Wife loves it says it sounds great and nice bass. Recently installed so cant comment on much else
5
found this helpful.Best selling similar products
• RMS Power: 650 Watts
• 2.5” 4-Layer High Temperature Black Aluminum Voice coil
• Carbon Fiber Enhanced Non-Pressed Paper Cone
• Custom High Roll foam surround with black nylon stitching
• 124 oz. Triple stacked High Energy ferrite magnet
• Die Cast aluminum vented basket
(2)
$149.99
• RMS Power: 650 Watts
• 2.5” 4-Layer High Temperature Black Aluminum Voice coil
• Carbon Fiber Enhanced Non-Pressed Paper Cone
• Custom High Roll foam surround with black nylon stitching
• 124 oz. Triple stacked High Energy ferrite magnet
• Die Cast aluminum vented basket
(1)
$149.99
• 200 Watts Max
• 100 Watts RMS
• Glass Fiber Reinforced Cone
• High-Strength Stamped Steel Frame
• FEA Optimized High-Power Neodymium Motor Structure
• Separate Optimized Crossover Module
$449.99
Save up to 10 different vehicles in your garage