3000W Consumer Line Series Monoblock Class D Amplifier
• RMS Power: 1800W x 1 @ 4 ohms, 3000W x 1 @ 2 ohms
• Total Peak Power: 6000W
• Adjustable Low Pass Filter
• High Quality Aluminum Heat Sink
• Dimensions: 7" W x 27.9" L x 2.2" H
• RMS Power: 1800W x 1 @ 4 ohms, 3000W x 1 @ 2 ohms
• Total Peak Power: 6000W
• Adjustable Low Pass Filter
• High Quality Aluminum Heat Sink
• Dimensions: 7" W x 27.9" L x 2.2" H
The Audiopipe Consumer Line series amplifiers were reengineered from the ground up in 2012 to provide plenty of high quality power for even the highest end sound system while keeping their footprint as compact as possible. Audiopipe didn’t skimp on the internals of these amps, the Consumer Line features the finest in electronic protection circuitry to protect against harmful short circuits, thermal overloads and overheating. These premium choice amplifiers are sure to impress.
The Consumer Line amplifiers are built with performance in mind, and a quick look under the hood of these amplifiers reveal oversized toroids. These toroids (basically just wire coils) help to regulate the voltage in the amplifier. By overbuilding them, Audiopipe ensures that every CL series amp puts out even, consistent power for the best possible sound, and the longest life from your components.
When redesigning the Consumer Line series, Audiopipe took great care in designing an amplifier that would not overheat. These amps feature a high quality aluminum heat sink with cooling fins running along each side and grills embedded in the top plate to ensure outstanding heat dissipation and prevent any unwanted heat related shutdowns.
The Audiopipe Consumer Line Class D monoblock amps are intended for hard hitting sound, so much so that they were designed for compatibility with 16V vehicle electrical systems. Because the CL series amps are capable of accepting a higher voltage than the standard 12V amplifier, they are able to produce much more power.
Internal Product ID:
81648
Great amp
I got this amp on 3 12inch bd3 banging loud. This amp can power anything you put on it guaranteed. You are going to an extra battery for sure
34
found this helpful.An EE's take on the bunk
Decent amplifier design, clamped output at 14v in under a reactive load is 3200w at 2ohm. pretty darned good even after an hour the amplifier never got too hot (above 70c is too hot). It's just fugly as sin.
21
found this helpful.great amp
its got lots of power hade to turn my gain down some it can blow ya subs my gain set low bass boost off i got it wire at 4 ohms still to loud
22
found this helpful.AudioPipe APCL-30001D
I have this amp running two AidioPipe TXX-BD3-15's at two ohms. The amp is only turned up a little over half way and pushing my 15's super hard. This amp is truelly a beast for the cost. I'm very impressed!
10
found this helpful.audiopipe amp
i own this amp and it is really impressive im powering 2 kicker cvx 15's in a 8cu ft box thats ported to factory specs in a dodge megacab and it slams also ohmed speakers to 1ohm upgraded alternator and 0 guage wiring
3
found this helpful.proud
All I can say is clean power, dont pull a bunch of juice and mean!!!!
Best selling similar products