1/0 or 4 AWG ANL Fuse Holder with Bright Nickel Plated Finish
Competition Series Power Distribution ANL Fuse Holder • One 1/0 or 4 Gauge in, one 1/0 or 4 Gauge out • Compatible with ANL Fuses • Solid brass with nickel plated finish • 24K Gold plated and water resistant
Learn more about the fbw911anlInternal Product ID:
20165
Tsunami FBW911-ANL
Im totally pissed off at this product. A set screw is way better han this to hold down your wire. Must be even cheaper to make. Anyway should be a 10 minute job but instead took more than an hour screwing with it and it still doesnt hold the wire secure. Wasted 10 bucks
6
found this helpful.Has a design I wasn't expecting.
Construction seems to be typical with some ANL fuse holders. O rings where the wire goes into the fuse holder to protect from the elements, along with o rings for the end caps. What threw me for a loop was, I had to solder the wires into the ends. A good thing about the changeable ends (1/0 or 4 ga) is that they swivel. The solder thing just isn't sitting well with me. If you need to change/upgrade down the road, this will become an inconvenience.
6
found this helpful.Most Secure
Simply push the wire thru then bend it backwards over the swiveling member and tighten. These are by far more secure than set screws, no solder, no crimping; just goo ole fashioned torque.
5
found this helpful.Great Fuse Holder
Fuse holder works great and is very flexible and easy to work with, connections are good and solid.
4
found this helpful.Best selling similar products