8 Gauge Power Amplifier Installation Kit for Systems up to 1000 Watts
8 Gauge Power Amplifier Installation Kit • Designed Specifically for Car Audio Systems up to 1000 Watts • Made from 100% Oxygen-Free Copper • Includes 2-Channel RCA Interconnect Cables • True-to-Gauge Cables/Wires
Learn more about the epak8blInternal Product ID:
40344
great
Good, last a very long time, very good sound and holds up.
5
found this helpful.ok
I bought this cause of the price. It work good I am running a Lanzar MXA224 (1000 watt rms bridged) pushing a 12" Kenwood KFC-W3013PS. I only have two bad things to say. Once it was hard to strip the wire and the connectors are horrile (bought my own). 2nd the remote wire was worthless, after running all my wires came to find out it didnt work.. I had mounted my amp to the box so I only needed about a foot of speacker wire. To fix the problem of the remote line not working i just used the remaing speacker wire as the remote. Problem FIXED. All in all it works fine.
4
found this helpful.Decent
This kit is not bad at all just under 8 awg and i think it deserves more appreatiation then the prior reviewer.
4
found this helpful.Good hookup!
Nice price and value. Will buy again.
3
found this helpful.lousy
The wire connectors cracked when I crimped them. had everything you need to do a good clean job but the connectors just weren't worth a fish scale. Spend a little more money. It will be worth it.
4
found this helpful.Its bullz audio
When you order bullz audio you get bullz audio quality. So in essence yes you get what you pay for. For your everyday 600 watt amp this setup is great for the price. This is not as bad as that one dude described on the other review.
Con- remote wire is basically fishing line, but you can run 14awg for remote which i would recomend or 12 if your splitting it for multiple amps.
3
found this helpful.Not true to gauge
Bought this kit mainly on the low price and fact it stated it was "true to gauge". Well, no surprise that is not in fact true to gauge. The wires all look to be more insulation and very little inner wire. I mean, these inner wires are as thin and flimsy as it gets. Ok, the power and ground wires arent THAT bad (thin but not terribly thin), but the remote and speaker wires are just about worthless. Also, the RCA cables are about the cheapest Ive ever seen. I tried the fit on my amp and they barely hold on...a few potholes or deep bass hits and these things will probably work themselves off. Luckily, I have a set of high grade RCAs I will be using instead of the set from this kit. And since Im only using this kit to run approx 40rms x 2, Im guessing the thin wires should be able to handle it.
The only seemingly well built piece of this set would be the fuse holder.
Bottom line...If you absolutely cant afford a few extra dollars and arent planning on running high power, this set should work fine for you. Otherwise, Id advise saving a few extra beans and getting something slightly better for you buck.
I will never knock SE, I think they are great and prices are just about unbeatable (esp when u factor in that most of their stuff also has free shipping).
4
found this helpful.Best selling similar products