600W Peak (300W RMS) 10" Punch Stage 3 Shallow Mount Dual 4-ohm Subwoofer
• Peak Power: 600 watts
• RMS Power: 300 watts
• Impedance: Dual 4 ohms
• Anodized Aluminum Cone
• Santoprene Rubber Surround
• Mount depth: 3.50"
• Sensitivity: 83 dB
• Peak Power: 600 watts
• RMS Power: 300 watts
• Impedance: Dual 4 ohms
• Anodized Aluminum Cone
• Santoprene Rubber Surround
• Mount depth: 3.50"
• Sensitivity: 83 dB
The Rockford Fosgate P3S 10" shallow mount subwoofer delivers Punch, even in depth limited situations. Rockford Fosgate understands all vehicles are not the same, and some cannot accommodate deep subwoofers. In the past, that meant no Bass. Not anymore! Now even depth challenged vehicles can have REAL Bass and the Dual Voice Coil allow configurations for every application. The P3SD4-10 Punch Series 10" Shallow Subwoofer has a peak power rating of 600 watts and a RMS rating of 300 watts. This sub will produce some earth shaking bass and is constructed with an anodized aluminum cone and a vertical attach surround technique. This woofer is also equipped with a 2-1/2" Voice coil and a protective PVC textured magnet cover. Add some bumps in your trunk and enhance your cars stereo system with this Rockford Fosgate Punch Series Subwoofer.
Anodized Aluminum Voice Coil Former
By using an anodized aluminum voice coil former on their subwoofers, Rockford Fosgate is able to dissipate heat from the voice coil more efficiently. A hot voice coil can melt the adhesive bonds, which will lead to eventual subwoofer failure. The aluminum voice coil former acts as a heat-sink to dissipate thermal build-up on the voice coil cool during high SPL conditions.
Conforms to CEA-2031
Rockford Fosgate has built this subwoofer to conform to the CEA-2031 loudspeaker power handling industry standards. This means that you can trust the subwoofer to have the capacity to safely handle the continuous (RMS) power rating. Having a CEA-2031 power handling is important when matching a subwoofer to an amplifier because the power ratings are accurate.
Stitched Tinsel Leads
To improve the reliability and performance by reducing fatigue and possible shorting, Rockford Fosgate has stitched the tinsel leads to the spider. The multipoint periodic stitching lead wires reduce the mass of the tinsel leads to spread the stress over a greater area. This improves the reliability and performance of the subwoofer.
VAST: Vertical Attach Surround Technique
In order to increase the surface area of the cone without causing any installation issues, Rockford Fosgate designed the Vertical Attach Surround Technique (VAST). By redesigning the manner in which the surround adheres to the basket, these speakers gain up to 25% more effective radiating cone area. This improves the nominal efficiency and maximum output.
Priced Individually
Internal Product ID:
43415
p3 shallow 10s
i put 2 p3 shallows under the back seat in my f150 and couldnt be happier. i only have a cheap amp pushing them for now and they are way louder then i would have ever expected out of 2 10s
53
found this helpful.Great little sub!
Put this in a Q-Logic custom box, 0.66 cubic ft., for a 06 Dodge Ram Quad, the box was expensive but worth it, and powered it with Rockford Fosgate P300X1. This little guy is a great upgrade for folks looking for some extra thump. Also put Fosgate in the doors and a Pioneer head. If you listen to rock or country this is a phenom with the correct box and head. If you want SPL in the tight space of the Dodge I would go with the loaded MTX.
47
found this helpful.Great subs!
I have two of these subs in my 2005 4 door 2500hd chevy silverado and that sound great they thus hard and clean I'm running them at 2 ohms with a nvx jad 1200.1d I love them they might not go as deep as full size but they sound great rockford all the way!
47
found this helpful.good
Excellent product. I would recommend to everyone to buy and head pretty good for being a shallow mount subwoofer
44
found this helpful.03 Tundra extended cab!!!!
I was told nothing fits in this truck except the Qforms sub box that holds 2- 8" shallow mount subs. This speaker was the solution. Made a new sub floor under the back seat *unbolted stock metal frame* and now I've got 10" sub where I was told there's nothing that fits. Sounds great super happy.
41
found this helpful.great value
Great sub! Performance is fantastic. I have it in a vented enclosure and sounds great.
36
found this helpful.Great Sub!!!!
I have 2 of these sub in my 05 colorado crew cab. Sounds nice and clean.
39
found this helpful.Good sub
If you just want some better quality sound than stock without taking up too much room, this is for you. If you're younger or looking for heavy bass, stay away. This shallow sub is supposed to be tucked away, who cares what it looks like.
I have mine set at 20Hz - 60/70Hz crossover frequency with a Rockford fosgate PBR 300x1 amp. This setup takes up almost no room in my little car, and it doesn't weigh a lot which is good. The bass output is decent to below par, but it's a good overall sound which I prefer now in my 30's. It isn't going to drain out your mid or high range at all, and it won't rattle your car or head to pieces. But it will annoy other drivers and your neighbors. It's a nice blend but nothing to write home about. Better than anything in an OEM setup for sure.
28
found this helpful.Great shallow subwoofer!
Great product, thumps good for being in a small sealed enclosure, hits hard when you want it to but nice and clean also for good sq builds.
27
found this helpful.Mildly ok
Decent product. I’m just not happy with it. Hits some notes great, others sound sloppy on this woofer. I’ve found it really hard to adjust & find the “sweet” spot. I’ve even taken it back to the professional shop that installed it & they said the same thing. It’s not terrible however, I do wish now that I would’ve went with another brand.
This product is temporarily out of stock. May we recommend...