Install a new car stereo in select 1990-2001 vehicles from Mazda
• Direct Connection to the factory harness
• Color coded wires for easy installation
• No cutting or splicing required
Please use our Fitment Guide to determine specific compatibility for the submodel and audio features
Internal Product ID:
4538
Great for DYI
made hooking the radio up a lot easier for someone who was doing it for the first time
28
found this helpful.easy
Worked like a charm. Wires all matched up as they should
26
found this helpful.Perfect match
This wiring harness made installation easy. This was my first stereo installation and I had only 1 wiring issue because of the instructions included. There was an issue with the power antenna wire, but I think the issue was with the original wire. Do not cut wire until you are sure of wiring installation.
24
found this helpful.makes things easy
great for that "no hack" installation.
26
found this helpful.Must have when replacing stereo
You need a wire harness to make your stereo swap as easy as possible, and this unit makes that possible.
25
found this helpful.Great buy!
I ordered and installed this wiring harness in my 01 Mazda Tribute six months ago and have never had any problems with it. It took less that 5 minutes to install
22
found this helpful.Not too bad, but theres better wire harnesses out there
Not too bad, better than nothing. I used this on a 1990 Mazda Rx-7 convertible. It may work good for other cars, but on my car it was wrong. The remote on for the factory amps was on the wrong plug. It is suppose to be on the larger plug at pin 10 (Brown/Red wire from the car). Where the remote wire was it went to 12V constant (blue/white) from the car. This kept my radio powered up all the time. I'm glad Pioneer has the remote trigger monitored and diode isolated from stupidity like that or I'd been getting a new radio. Also one of the crimp terminals was bent a little, when plugged the connector in, it tried to bend the pin. Just look out for that. I'm a old veteran car stereo installer with 14 years experience, and this is one of the worst connectors I have seen. Just remember to specify you'd like a Metra wire harness, you'll probally be happier. :)
22
found this helpful.No Ground?
This wiring harness worked good, except there is no ground wire on the plug. Ground wire is its own free wire in the radio slot. Used in a 1993 Miata.
20
found this helpful.Good Product
Did exactly what I needed, well made harness and an easy install.
18
found this helpful.It is an accurate adapter
I was able to use the adapter in my 2000 Mazda 626 and all the wires matched up. Used this adapter to go from stock Mazda head unit and cassette player to Sony MEX-BT5700U
16
found this helpful.Best selling similar products