Crunch P1100.2

I just ordered this amp and am dieing to try it out. I'm going to use it to run two SSL 15's rated at 900rms each. I currently have them on a PUNCH P300.2 and there getting max 175rms each and hit good as is. this amp claims to do around 250rms at 2ohms x2 channels. I run all DVC 4ohm 15" woofers.

I love this amp! I have it hooked to 2 pioneer 10s and it gives em a lot of power. Its a really reliable amp. Never blown a single fuse and no distortion.

I have this running two Kicker 07C12-4 wired up at two ohm, and this thing is still running even though it says its minimum is 4 ohm but still runs it just fine. Never blown a single fuse. Very pleased with the quality and sound output. I love it! Handles the lows really good and it does output stuff way below 30hz just the filter doesn't go below that. Running some bass tests and I can see 5hz well, so it does output at those levels.

This amp never blew any fuses or subs. I had it in my 1995 buick hooked up to two 12" alpines and it was turning heads.

This amp will push some power but sadly enough its frequency response is only down to 30hz i love lows and this just aint cuttin it for me. I dont understand why the company would do that if the past models even though 1000 watts, produced 20hz.

e2 400W Single Amplifier Wiring Kit • 6.5mm Power/Ground (Equivalent in Strands to Most Other "8 Gauge" Kits) • 17 ft. Twisted Hex RCA Interconnect Cables • 17 ft. Power and Ground Cables