|
Average Customer Rating is 3.0 out of 5 stars:
Share your thoughts with others:
|
|
Average Attributes Rating:
| Durability | | 3.7 |
| Value | | 3.3 |
| Features | | 2.7 |
| Design | | 4.0 |
| Usability | | 2.7 |
| what's this? |
|
|
Quick Comparison:
|
|
Most Helpful Customer Reviews:
|
Review by
Pastrol from Ontario, Canada
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
Simply push the wire thru then bend it backwards over the swiveling member and tighten. These are by far more secure than set screws, no solder, no crimping; just goo ole fashioned torque.
|
|
Review by
Dustin from Austin, TX
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
Construction seems to be typical with some ANL fuse holders. O rings where the wire goes into the fuse holder to protect from the elements, along with o rings for the end caps. What threw me for a loop was, I had to solder the wires into the ends. A good thing about the changeable ends (1/0 or 4 ga) is that they swivel. The solder thing just isn't sitting well with me. If you need to change/upgrade down the road, this will become an inconvenience.
|
|
Review by
EARLYBIRD from TAYLORSVILLE
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
Im totally pissed off at this product. A set screw is way better han this to hold down your wire. Must be even cheaper to make. Anyway should be a 10 minute job but instead took more than an hour screwing with it and it still doesnt hold the wire secure. Wasted 10 bucks
|
Customer Service
