|
Average Customer Rating is 4.1 out of 5 stars:
Share your thoughts with others:
|
|
Average Attributes Rating:
| Durability |
|
4.1 |
| Value |
|
4.6 |
| Features |
|
4.3 |
| Design |
|
4.1 |
| Usability |
|
4.6 |
|
what's this?
|
|
|
Quick Comparison:
|
|
Most Helpful Customer Reviews:
|
Review by
Dont worry about it from somewhere here
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
You have to understand the ratings of this amp to not be surprised. Look at the fuse rating at 25Ax2. That is a 50A peak. At the mentioned 2ohm, 1200W rms, you are pushing 48.989Amps, which means that the 1200watts is not an rms, but a peak. Your rms is actually at about 420watts for this amplifier...It is very overrated. And that is with a 70% efficiency rating @28.98A @14.49V. Not much higher than your BATT supplies. So, the voltage gain is very small here. THIS is why a 2000W amp can cost around $100. Gotta do the research.
|
|
Review by
Derrick from Brevard,NC
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
Me and my buddy ordered this amp from Sonic last week, and it arrived today. Customer service was swift and EXCELLENT as usual. I'm going to keep it simple here by saying you shouldn't waste your money on this, even if you're on a budget. Our amp malfunctioned wired at 2ohms. The ONLY way we could get any performance was to wire the subs @4ohms, and even then, performance was pathetic. You get what you pay for here and not a bit more. I would not recommend this amp to ANYONE. If you're on a tight budget, buy a brand named used amp instead of burning your hard earned dollars on this.
|
|
Review by
johnny boy from Rio Rico, AZ
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
i bought this amp and it sucked i used for around 6 months and i blowed my two fuses and it stopped working this amp is just waste of money buy something better when i opened the amp to see what was wrong transistors were bad weld annd thats how ilost 100 buck on this piece of ****
|
|
Review by
Rodney from HERTFORD, NC
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
Good amp recomend to anybody.has lots of power.had it for 2 years never had any problems
|
|
Review by
thevenin2 from Utah
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
This amp starts to clip the sine wave at about 37-39 volts with the engine running. So you do that math. Into a nominal load of 4 ohms, that is 380 watts. 2ohm, 760 watts, which is right around 50 amps so questionable about stock fuses.
|
