Expert Service 1-877-289-7664 [Hours]

Expert advice for 14 years

Mackie SRM450V2

12" 2-Way Powered SR Loudspeaker

We apologize

This item has been discontinued

Product Features:
  • Mackie SRM450V2 12" 2-Way Powered SR Loudspeaker
  • Power Handling:
    • Low Frequency: 300 watts
    • High Frequency: 100 watts
  • 12 neodymium woofer has less mass and a quicker response providing a punchy response from such a small loudspeaker
  • Titanium compression driver enhances clarity
  • Class D topology and Fast Recovery circuitry produce more power and clarity
  • 1.75" titanium tweeter for superior high frequency clarity
  • Built-in limiter supplies less distortion at peak levels
  • Ultra-wide, refined dispersion via HF waveguide
  • Built-in phase accurate 24dB Linkwitz-Riley electronic crossover
  • Electronic time correction, phase alignment and EQ for studio quality sound
  • 5-Way protection (Over excursion, thermal, low line voltage, driver protection, low frequency roll-off)
  • 3 Handles (one top, one on each side)
  • Signal, peak, power-on, and thermal display LED's
  • Lightweight and strong polypropylene cabinet
  • Mic/line input and pass-thru connector
  • Flyable, Pole mountable, Floor wedge-able
  • 1-year Manufacturer's warranty
Product Specifications:
  • Frequency Response: 55-18,000 Hz
  • THD (Total Harmonic Distortion): 0.1%
  • Sensitivity: 98dB
  • Impedance: 8 ohm
  • Material: Polypropylene
  • Finish: Midnight Blue textured
  • Power Requirements: 120 VAC, 60 Hz
  • AC Power Connector: 3-Pin IEC, 250 VAC
  • Horizontal Coverage: 90°
  • Vertical Coverage: 45°
  • High Frequency Magnet: Ceramic
  • Low Frequency Magnet: Neodymium
  • Maximum SPL: 124dB
  • Weight: 40 lbs
  • Dimensions: 14-13/16"D x 15-7/16"W x 26"H

Loudspeaker Specifications

Type
This is the type of professional loudspeaker. Active loudspeakers have a built-in amplifier to power the speakers. Passive loudspeakers require an external amplifier to be properly powered.
Active
High Frequency Driver Size
This is the size of the high frequency driver. Common sizes include 1", 1-1/2" and 2".
1-3/4"
Low Frequency Driver Size
This is the size of the low frequency driver. Common sizes include 10", 12", and 15".
12" Driver
Frequency Response
The range of frequencies the speaker will reproduce (lowest frequency to the highest). Bigger is better, meaning the wider the range, the better. The optimal range is 20 - 20,000 Hz (which is the range of human hearing).
55 - 18,000 Hz
Sensitivity
An efficiency or sensitivity rating tells you how effectively a speaker converts power into sound. The higher the number, the more efficient the speaker and the louder it will play with the same input power. An efficient speaker helps you maximize your available power. Most sensitivity ratings measure the speaker's output with 1 watt of input, 1 meter from the speaker. Some speakers' sensitivity is measured with 2.83 volts of input, instead of 1 watt.
 
Efficiency (1w/1m) is not an accurate indicator of a subwoofer's output capability and should not be used as a comparison to other speakers or subwoofers to determine which one is "louder".
98 dB
Maximum Sound Pressure Level SPL
This is the maximum Sound Pressure Level (SPL) of the professional loudspeaker. The higher the SPL rating, the louder the monitors are able to go.
124 dB
Dispersion
This is the horizontal and vertical audio dispersion of the professional loudspeaker. The dispersion is measured in degrees.
90° H x 45° V

Active Power Specifications

Peak Power Rating
This is the peak power output that the active loudspeakers is rated at.
800 watts
Continuous Power Rating
This is the continuous power output that the active loudspeakers is rated at.
400 watts
Amplifier Class
This is the class of amplifier inside the active loudspeaker.
D
Amplifier Controls
These are the different types of controls, adjustments, and dials that are on the active loudspeaker.
Level Control
High-Pass Filter (HPF)
Low-pass Filter (LPF)
Contour
Power On/Off
Timed Turnoff
Built-in Equalizer
If the active loudspeaker has an internal equalizer it will be identified here.
No

Physical Features

Inputs
These are the types of input connections that connect to the professional loudspeaker.
XLR
Outputs
These are the types of output connections that connect to the professional loudspeaker.
XLR
Enclosure Material
This is the material that the speaker's enclosure is made out of.
Polypropylene
Carrying Handles
Carrying handles are found on the enclosure and they make transporting the speaker easier.
Yes
Speaker Mounts
Speaker mounts enable the loudspeaker to be mounted to a stand or tripod.
Yes
Height
The height of the item, measured from top to bottom, in inches.
26"
Width
The width of the item from left to right (side-to-side) measured in inches.
15-7/16"
Depth
The front-to-rear depth of the item, in inches. If the item is angled or slanted, this value is the bottom measurement.
14-13/16"
Weight (Pounds)
This is the weight of the item in pounds (lbs).
40 lbs

Warranty and Return Policy

Parts Warranty Duration
1 year
Labor Warranty Duration
1 year
Warranty Provider
Manufacturer

Summary of Customer Ratings & Reviews

Rating Distribution

5 Star
0%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%

Average Attribution Rating

Durability
0.0
Value
0.0
Features
0.0
Design
0.0
Usability
0.0

Product Summary

Manufacturer

Model Number

SRM450V2

UPC

663961028232

Weight

40.00lbs

Internal SKU

srm450v2

Internal Product ID

24170

Sonic Electronix Wiring Guide

Wiring Diagram Legend

Warning: The image depicted shows the resistance change when wiring multiple subwoofer terminals. Please refer to your subwoofer's owner's manual for the proper wiring of its terminals. Sonic Electronix, Inc. is not responsible for damage caused to your audio system or vehicle due to improper installation. Please call tech support at 1-877-289-7664 if you require additional assistance.

Product Name: Mackie SRM450V2