|
Average Customer Rating is 4.0 out of 5 stars:
Share your thoughts with others:
|
|
Average Attributes Rating:
| Durability | | 4.7 |
| Value | | 4.7 |
| Features | | 4.3 |
| Design | | 4.0 |
| Usability | | 3.7 |
| what's this? |
|
|
Most Helpful Customer Reviews:
|
Review by
Bo from Bountiful, UT
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
This is a good little amp. I was told Power Acoustik's are good amps, and mine is. My only problem is that I bought it to power my Fosgate T0, and it's not doing the job I expected. My sub hits super clean and semi-hard. It just doesn't get as loud as I had hoped for.. My buddy has a JL W3 hooked up to a MTX 600W amp and it easily hits twice as hard.. be sure to use this amp with a lower end sub.
|
|
Review by
jerron from burlington, IA
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
I've been using this amp for about 6 months now and I like it a lot it's powering my Eclipse SW8010 makes it pound pretty hard the one thing I don't like about it is I'm running the required gauge of wire and I turn the knob to half an its as high as the amp can go other then that I've always used power acoustik amps
|
|
Review by
jethro from Centerville,Iowa
| Overall |
|
| Durability |
|
| Value |
|
| Features |
|
| Design |
|
| Usability |
|
|
I bought this amp and thought it would be a great amp, but it found out it was way overated. What I mean is it hits hard but when it supose to push 700 watts rms @ 4 ohms and I'm rumming a 350 watt rms @ 4 ohm walmart sub. You would think it would blow that sub easy, but it didnt. My nephew has a 1000 watt kenwood amp tthat is pushing the same kind of sub and it hits 10 times harder. Its not a bad amp, but im going to go with a name brand amp I trust.
|
Customer Service
