Rockford Fosgate Power T10001bd (Silver/Red Box)

I'm assuming rockford had a mad scientist from the depths of Hades engineer this thing to destroy all humanity!! crazy power. 1000wrms at 1ohm but it slaps my 2000wrms stroker around like a red headed step child. If you can find one of these oldies but goldies pick it up for sure. Ran it at 2ohms on my 1000wrms pioneer and it pounded. actually blew one had to send back for replacement!!!!! if only rockford still had this quality of product today. sadly i got a deal on CV amp to match the stroker and sold the mighty monster. could use a bass boost on the amp but you can get remote

I have this amp connected to an Orion Hcca,
i was a bit worried at first because people would tell me that it wouldn't pick it up. Then i connected it and it is too strong for it. i have to keep the bass low. If i keep it high, my ears start to hurt. So far this amp has easily been able to pick up all the subs that i tried to it. So im very happy with it.

Extremely underrated. Very well built. You will never buy another sub amp again unless you want something smaller. Just look at how many second hand Fosgate products are out there and that should speak to the quality of there products. I have yet to find a setup I cant power. Buy this thing it is better than the newer model. Only reason I didn't give it 5 stars across the board is the cover for the controls. The screws are hard to line up and it needs a digital read out on the crossover and gain. I don't think anyone has that though

First off, although it says 1000 watt rms @ 1 ohm, it was rated at 1546 watts rms @ 1 ohm. So I got a 1500 watt rms amp for the price of a 1000 watts rms amp! Got this with a fosgate 2 farad cap, and fosgate t110d04, and built the box to the specs on fosgates website, except used 1" MDF. This system bumps hard. My wife really hates, but my girlfriend loves it!

Although it says the amp wont work with older remote bass controls, the wire is still the same, so I did not have to re-run the wire, but make sure you use the new control and not the old one. just unplug the old control at the knob (network cord) and plug in the new! Done.

Very happy with Sonic Electronics service and delivery speed. I live close enough that they used a local carrier, received faster that if they would have went UPS.

best amp to get...got it hook up to two 12" Kicker CVX.
loving da bass...