Hifonics Brutus BRZ2400.1D

Lots of Power!

BAD A$$ AMP! I've ran it at both 1 AND 2 ohms and it slams hard either way, although it obviously hits hardest at 1. If your looking for both SPL and SQ than you've found it in this amp. I recommend beefing up your electric system by AT LEAST doing the BIG 3 UPGRADE and getting a couple STRONG subs that can handle this kind of power. This is not a small, novelty, amp that you get with a $250 system kit. This is a no bull ****, playen with the big boys, rattle your brains out, kick *** amp. I had my system turned up in my back yard while I had to run back in the house for something just to find that not only all the windows in the house rattling but also all the dishes in the kitchen cabinets rattling too! I totally recommend this amp with no question.

lot of bang for your bucks

I brouth this amp bout 2 months ago I just hook it up.let me tell anyone that says this amp is a waste of time they CRAZY.this it the truthi got it on 2 12s p3s for now but it going on 2 15.4 hcca. so for you out there buy this its go and its cea rated

BRE2500.1d

I own the BRUTUS ELITE BRE2500.1d. If you don't know what this is, look it up. It's the dealer only Brutus model, retail protected, not to be sold online, or bought other then a official Maxxsonics dealer. The BRE2500.1d is an upgraded version of the BRZ2400.1d. The BRZ2400.1d is CEA-2006 certified, which means it meets or exceeds the national amplifier output standard. CEA-2006 certified amplifiers are guaranteed to produced the power they are rated for, at a certain voltage and ohm load. These amps are cheap, but these are not like your average knockoff, that claims 2000, and only does 600. These are TRUE wattage amps. By the way, the BRZ2400.1d is capable of stacking, which means that you can hook the amps up together in unison and make both amp perform as a single unit, produces double power at 2ohm. Bottom line, these are the best amplfiers you are going to find at this price level... Cheers.

Great Bang For Your Buck

This is basically a 2000 watt RMS amp.
On good electrical systems this amp will do about 1900~2k RMS.
This amps internals are almost identical to the SQ2200.
The main difference between the two is the signal input section and that the SQ uses lesser quality caps.
If you were to have the two amps side by side with the boards showing, you will see that they are the same.
I highly recommend this amp. It literally puts out the same power as a SQ2200 (an almost $500 amp) for half the cost, and its better built.
However, no stock four cylinder electrical system will do for this current hungry beast.
A high output alternator, a nice battery, some high quality 1/0 power and ground with the big three under the hood IS A MUST.
NO RA***R or A******N B**S wire will do...
~end rant~

very powerful amp

Great amp. There are not a lot of reviews because these amps just came out and let me tell u they are no joke. I can hardly sit in my car when the volume is turned up. The bass is very clean and loud. These amps are cea compliant so you cant go wrong. I took the risk and brought two of these amps and i am more than satisfied. I got way more than my moneys worth and for some reason these amps dont get hot at all great work hifonics !!!!! Autotek and Hifonics the best amps ever made period.....

Oh, my, god. Becky, look at her amp!! it is so big. [scoff]

I installed this amp along with an auxiliary battery, cap, and big 3 running a single t2 15 and it impresses me everytime i listen to it. With the volume up it shakes the dash and whole car so bad i have to use the remote to turn down the volume or wait for the song to end, no joke. After listening for hours the amp is still relatively cool to the touch, even with it installed @1 ohm. My gain is a little over halfway turned up and bass boost is right at the lowest setting. No distortion or clipping. i also reviewed the rockford fosgate t2 15 dual 2 ohm on this site. might post another review after i get the set-up metered. I'm hoping for low to mid 140's. I also ran the amp on two type r 12s @4 ohms in a sealed box before the t2. The amp was barely turned up and made them slam even @4 ohms with phenomenal sound quality. Put the time and effort into a quality install and you wont be disappointed.

Great Product!

This amp is extremely efficient. Currently running it with stock alt and bat. With absolutely no dimming. However I am going to be doing the big 3 and adding an extra battery for maximum performance. And also, the amp is pushing two RE Audio SXX 15's with ease...the amp barely gets warm.

Kick a** amp!

I have this amp hooked up @ 1700 watts to my two 10" RE's SX 2ohm subwoofers and man the power this amp produces is tremendous!!! I have bass for days and my amp never heats up!!! =) the controls are easy to use and the quality of this amp is great for the price!! As long as u install it properly you will have no problems!

BRUTE

Just installed the amp a few hours ago. very nice finish and very easy and sturdy connections. I had a power acoustik 4000 bamf which was rated higher at 4 ohms then the hifonics, but the brutus was easily louder and cleaner. I am pushing a Fi Q 18 with the brutus and it is hitting cleaner and harder then ever. If i had a choice to buy this amp again i would do it with out thinking. i would recommend this amp to anyone.

hifonics brutus

I have had a couple different kind of amps the boss am a different hifonics amp but this is the truth I still have it no problems with it and it great love this amp