Balanced differential inputs make KICKER ZX Amplifiers compatible with any factory radios
Eliminates unwanted noise in a system
Boost, gain, and crossover frequencies are top-mounted for easy access, and a handy protection indicator featuring a new flashing yellow low-voltage light enhances the end panel
Bridgeable operation
Speaker-level inputs compatible (switchable) through RCA connection
Preamp RCA outputs
Automatic turn on modes: remote, DC offset, or signal sense
Thermal, voltage, and short circuit protection circuitry
Fixed low-pass filter (80 Hz, 24 dB/octave)
Subsonic Filter (24 dB at 25 Hz)
CEA-2006 compliant amplifier
Frequency response: 25-200 Hz
Dimensions: 13-1/2"L x 9-5/8"W x 2-1/8"H
8-gauge power and ground leads recommended. Contact us for information regarding a discount on a select amplifier kit when purchased together.
This amp is awesome, I can run it at full power all day long and it never goes into protection. I would also suggest 4 gauge wiring as it fits no problem.
May 4, 2009
Pounds
Overall
Durability
Value
Features
Design
Usability
Review written by Beeans from Idaho Falls, ID
I hooked this little guy up with one of the new kicker 400w 07cvr 12", in a smaller sealed box, like 1.3 sq. ft. My amp was rated by kicker at 325 rms watts so i turned it al the way up cause i knew the speaker would handle it... ummm this thing made me and my lady nasious after like 10 minutes.... pounds sooo hard, flexes the roof, and trunk in my 98 jetta. Awesome price for bump.
March 14, 2009
Get this amp
Overall
Durability
Value
Features
Design
Usability
Review written by Ryan from new orleans
This amp puts out some power. I was worried about it being 300 watts but my worries are over. Buy this amp
March 10, 2009
Good price great amp
Overall
Durability
Value
Features
Design
Usability
Review written by sparky from winnipeg, manitoba, Canada
I had just had my stereo system ripped off so i paired this new zx300.1 up with a 4 ohm 10" cvt kicker sub in a shallow sub box cause its in my ext cab ranger and this thing amazed me it pounds like crazy and at the same time it manages to stay clear without a lot of distortion. I have it hooked up to a 05 alpine cda9855 with 5v preouts and crossover contols which if your anywhich serious is a great idea so you can filter the high freq's out of the sub signal. but back to the amp i dont leave it near turned up all the way cause theres no need. it beats the hell out of my previous setup which was an alpine v12 400rms and a 10" kenwood 700w max.
November 18, 2008
Great
Overall
Durability
Value
Features
Design
Usability
Review written by cody from clarksville, IN
I bought this just wanting to get a cheap amplifier and damn this thing runs my Rockford Fosgate P3 to the max. I cant believe it pushes so much power. I have 3 other high powered amp and this beats them all.
8 Gauge Single Amp Power Kit • 20 ft. of 8 AWG Power Wire • 3 ft. of 8 AWG Ground Wire • 20 ft. of 16 AWG Remote Lead • 50A Maxi Fuse and Holder
Free Ground Shipping within the 48 states
