Customer Ratings & Reviews

A valuable installation tool

Worked very well when putting Polk DXi 6.5s in my 98 Ford Ranger. Not very thick plastic, but that worked for me, since I didn't have much room behind the factory door panel. They are way more convenient than making your own adapter. You'll have to drill your own holes for the speaker mounts, and/or dremel them out a tad if your speakers need a larger cutout, but I used the measurements beforehand and they worked perfectly. Very nice.

Perfect

Just too easy and hard to hold when you install it

Fit Perfect, nice adapters on a budget!

Fit Perfect, nice adapters on a budget!

These adapters are not usable for most speakers

I was trying to use these to install speakers in my 09' Ford Escape. The mounting holes are correct but the speaker cutout is not big enough. Not sure what they used to model the design but not usable for most speakers. The description says they are for 6 1/2" but hole size is undersized. I ended up making my own using 1/2" plywood at a fraction of the cost.

Time saving, great value......

I have been installing car audio for years. I would recommend this product to any amateur or expert installer. This was very easy to install and cuts time, compared to creating adapter out of ABS plastic. I have installed in several ford vehicles and was a perfect fit for the application. Thanks!

high quality product!

This product was made with quality. But unfortunately for me the units were made to thick to install in my 07' Mazda speed 3 door panels. Other than that, my shipments arrived on time and in perfect condition. Would order from again!

Clean fit.

Installed in a 2005 Ford F150 FX4 supercab.

Clean installation with the Clarion SRG1621R i bought from this website as well, with no cutting or drilling.

Good Adapter!

Was able to tap new holes in the plate for mounting a 6.5" woofer (Polk MM 6501) in the doors of my 2014 Mustang. Perfect fit to the factory mounting location.

Good

These fit my 6.5 inch coaxials in the cutout like they said. I did have to carefully drill new holes where this particular speaker needed to be mounted and it turned out well. There may be some 6.5's that won't fit in the opening, but mine did. They fit the 6x8 opening in the truck perfectly and the screw openings were right on the money.

Good speaker adapter

I use this with 5.25 inch speakers in the rear of a 1996 Ford F150. It holds the speakers in 6x8 hole very well, but just make sure you use larger screws. To completely seal the speakers, I'd recommend using Dynamat or a similar product to cover the adapter. I also used this with Pioneer 6.5s.

Good product, ok fit.

Pretty basic item here. Solid thickness on the mounts. Did not fit great on my 2008 Ford Mustang. I had to force it in place, but it did go in with some effort. Speaker openings were the right size.

My concern.

In my own experience with this product i'm not feel comfortable because I ordered the Scosche SA68 Adapters for my kicker RS65.2 component but it didn't fit. The holes are smaller than my kickers.

Cool adapters

They didn't fit exactly 100% and that extra thickness pushed the speaker out so the stock grill could not fit. But with some cutting and shaving i got it to fit perfectly! The speaker did fit in it well which was the main thing.

they work!

I used these so I could install Polk 6.5" speakers into my 6X8 door holes and they worked fine!

Made me look talented!!!

I used these on my Ford Expedition, fit great! I see some people had trouble fitting their 6.5" speakers in, but my Alpine 610's and 610c's fit in easily. For a brief moment I felt like an installer! (They wanted a $100 to put them in. I couldn't afford it.)

Adapter for 6 x 9 car speakers.

Although the speakers were a different size than I had originally planned, I was still able to modify these adapters to fit my application. Just having something sturdy to mount the speakers to before fitting them into the car door is very helpful. Great quality product overall.

Great!

Great Price. Very durable design. I went looking all over locally to find these at a store. Come to find that NO stores in my area carried ANYTHING like this. Worked Like a Charm Fitting My Speakers to my New car after taking them out of my old one.

perfect

These work pefect! Just what I needed! Speakers fit perfect now with no problems, thanks guys!

Cutting required for 6-1/2" speakers

The plates are ready to go if you plan to install 5-1/4" speakers; however you will need a jigsaw to cut the hole bigger if you want to install 6-1/2" speakers.

No brainer

Fit well with no need for cutting, all holes lined up just as they should! This was great for my custom install.

Cheap, easy and high quality

Very good way to get better sound quality out of you're speakers. I ,like many, prefer and feel that round speakers have a better sound quality than oval ones. A lot of cars only have oval slots for speakers and this is an easy way to solve that problem.

May Not Fit

I bought these to replace a 6x8" speaker with a 6.5" speaker. Unfortunately this bracket is not sufficient, at least for the speaker I chose (JL Audio TR650-CSi). The cut out on the Scosche is a 5" diameter. However, the speaker requires a 5 5/8" diameter. You can modify the bracket by using a dremel or other type of tool to widen the cut-out diameter. However, this would only leave me with about 1/16" on either end after enlarging it enough for the speaker...might as well cut it in half at that point (total height is 5 11/16" on the bracket).

It seems like it would be perfect for a 5 1/4" speaker some 6.5" speakers as well. You just need to make sure it is not too small, otherwise you are better off making your own bracket. All that being said, it is well made and I would recommend it under the proper circumstances.

Did not fit my 6.5in speakers

Ordered a set to go along w/ my 6.5in speakers. The speakers were too large for the hole on the SA68. I had to trace the diameter of the speaker on to the SA68s and use a dremel to cut out the difference

Does the job

What can I say, if you need an adapter to fit your 5 1/4 speakers into a 6x8 opening this is the perfect thing. However, it is hard to fit 6 1/2 inch speakers and requires drilling new holes

6 1/2s dont fit.

basicly 6 1/2s dont fit i had to dremel took the heck out of them to get them to fit. sucks but they r in. the became very flimsy with all the dremeling. maybee work for somthing else but didnt for me

not worth it

I should have spent the extra time and made my own. I had to take time and do extensive fitting.

Works great

Easy to install and price was right. Better than making your own.

6.5s do not fit!!

It doesn't even fit a small 6.5 speaker I tried a alpine sxe-1725s.

By Nieco on March 3, 2016 Verified purchase

Perfect fit!

Worked great with my Ford Explorer. Fit right into the factory 6x8 setting and hifonics Zues 5 1/4 speakers fit perfect. Worth the money to upgrade speakers.

By Anonymous on August 16, 2018 Verified purchase

Works great for 2013 mazda3

Recommend for front and rear doors for 2013 mazda3 and 6.5 polk

Do your research

These are very good adapters, however i had to modify them for my JL C650 speakers. I didnt do enough research to make sure i was getting the correct ones. But even modifying them was a breeze and they worked great and were a perfect fit in my truck.

Adapter

A must have to pit speakers in a 6 x 8 opening. Great buy

Will not work on 6 1/2 inch speakers

These adaptors are recommended to mount round 6 1/2 inch speakers in oval 6x8 mounts(2013 f150) . The holes for speakets are not big enough and there is not enough material to cut out and make work. Had to return for credit.

Will not work on 6 1/2 inch speakers

These adaptors are recommended to mount round 6 1/2 inch speakers in oval 6x8 mounts(2013 f150) . The holes for speakets are not big enough and there is not enough material to cut out and make work. Had to return for credit.

By Joseph on April 20, 2022 Verified purchase

clean and crisp

sound is clean, clear and crisp. for the price im shocked at how good they sound

Great!

Very solid product for the price. Would recommend to anyone.

Good Speakers

Good sounding speakers that are easy to install. They also look much better than the speakers replaced.

ok for rear fill

I bought these because the ones we bought for our Mazda 6 sounded great (they were 6.5)... this pair paled in comparison. They sound ok as rear fill when singled out but that's it I wouldn't rely on them for much more than that. Given their size and rating I expected more butt should have known better. Either way hard to beat for the price. Would I buy them again probably not. Next time I'll buy a set of 6" mid basses and make them work.

By Ben on May 7, 2017 Verified purchase

Sound good

These speakers sound very good. I used them for a boombox project and they sound really good, couldn't ask for more. People say they have no bass but they have bass you would expect from a 5 inch speakers. Bass won't disappoint you. You won't regret buying these speakers. That's coming from someone who is picky.

Awesome speakers!!

The sound, price, and quality are great! Everyone should have a front and rear set to put in there car to hear the difference!

Great speakers

Great sound and fit. I am pleased with my purchase of these.

Great package everything I needed

The panels were a drag but the speakers snapped right in no problem the kit of wires was great sounds real good can't wait for my subwoofer box to show

By BD. on December 27, 2017 Verified purchase

Great value

I bought many of the polk speakers over the year , best all around sound great up grade over a stock speaker , and work great with an amp. would and have bought over and over.

Good speakers

Good set of speakers, especially for the money. I installed them in a 2015 Indian Chieftain teplacing the stock speakers. There is no comparison now, these speakers made a vast improvement.

Polk Audio DXi521

Trued Polk quality at a very affordable price. Sound surprisingly good.

By Wes on December 27, 2016 Verified purchase