Customer Ratings & Reviews

High Quality stuff

This gear gives the look, feel and performance of what I was expecting from it, my truck wiring in my 2013 Challenger SRT8 is clean and professional looking, I would recommend this product.

Stinger for the win.

I would recommend this product mainly to high-end audio fanatics. Yes, you can put smaller amperage fuses in it. But...
Why would you? An excellent piece. I now have two in my car. One for lighting and effects, and the other for audio equipmemt. Both seem to be pristine even after the one has been abused for almost a full year.
Long story short, need juice? Get this.

well built, great value

I purchased this as a replacement maxi fuse block for a unit Tiffany Coach builders used in our limo bus. The original block used flimsy copper tension clamp type that eventually lost its tension allowing the fuses to lose connection and our rear units to power done and reset. This block is much better quality and much sturdier build. The plated terminals done look like they will lose holding power fora while to come and the lugs have high quality inverted hex screws that sit below the surface to avoid ribbing on any writes laying across. The plastic cover ensures no shorting of any wires at any time and also keeps the fuses from moving, reducing the possibility of fatiguing the terminals over time. Overall, it was a little pricey, but you get what you pay for.

Great

Works perfect and looks great what else can i really say about a distribution block?

great value

outstanding distribution block that has easy asses for the maxi fuses.

Great

Great product, best money can buy...Grab the stinger spd5623 if you need it, great investment.

Love it in my F150

I needed a solution to having so many wires connected to my battery. This simplified that with a 0 gauge from my Xscorpion DBT024RP battery terminal to my new distro block. and with the 100 amp MAXI fuses this was a done deal. wish we could post pix since I made a custom bracket for mounting under the hood

Favorite fuse holder

I like this one because you can quickly change fuse without any tools.

By Anonymous on August 17, 2019 Verified purchase

Good product

Recommend if your running 4 amps/processors that don't have built in fuses. Made by Phoenix Gold if you didn't know. You just need to figure out what amp fuses you'll need sold separately.

By Chad on September 23, 2017 Verified purchase

Good dis block for over 4000 watt

Love it worth the money works just right for large amp

Better than Chinese gauges

It's about a 1/2 volt low and 2/12 Amps low but it's much better than the Chinese units that you see. It alows me to monitor my hho system to my satisfaction. Works well but not exactly accurate.

Perfect for multi amp setup

I bought 2 of these distro blocks. I used one for power distro and one for ground. Ran Sky High 0 gauge from battery to the distro block in my trunk, then ran 2 4 gauge wires to amplifiers about 18 inches a piece. Same for my ground, coming from my rear seat bolt with the 0 gauge wire, split into 2 4 gauge wires about a foot

By Reggie on December 29, 2022 Verified purchase

Useful

I like that you can access the fuses without removing the cover. I also like that it is MAXI fuses, which you can get at just about any parts store. The Cover is a little flimsy and i put a few dabs of glue on it to make sure it doesn't come off.

By joel on August 5, 2022 Verified purchase

Stinger good fuse holder

Good product would order again if needed....

By Shane C on May 7, 2026 Verified purchase