Monster Cable MPC I306 6C-5M

Great

I would recommend this if your amps are close because they dont split but so far. i am using it on 2 amps. eclipse za1200 and kicker 4 channel. i had another brand from w****** and these are a lot better and they grip so much better. i used the offer and saved 10 bucks

Monster Cable

BEST CABLE FOR RUNNING SUB, AND FRONT AND REAR HIGHS ON AN AMP, ONE WIRE, EASIER TO HIDE, DURABLE GREAT SOUND NO COMPLAINTS

Great Quality!

I installed this on Pioneer DVD AVH-P5980 JL Audio A6450 JL XR-650-CSI bi-amplified JL 10w0-4 bridge KnuKonceptz/Kicker Cables. Easy to install, all connectors are short, color coded, its like a 4AWG power cable. Overall I´m pleased with its results, compared with a few other cables and decided to stay with these!

Moster 6 channel RCA's

I had bought this thinking it was a 4 channel lol, Just have and extra 2 channels now, This cable is great nice think insulation and no noise. If you are running multiple amps and your amps don't have outputs this is the way to go.

Great cables, little expensive

I am running these cables on a Kenwood deck with 4 Volt RCA outs for front, rear, and sub to a 5 channel Fosgate amp. These cables are a little on the expensive side, but if you want quality of sound, and a clean look at both ends, and a single wire to run this is for you. I am more than happy with the quality this provides. Zero noise, and good quality connectors which are labeled at both ends to avoid confusion. The wire in the middle is about the same size as a 4 guage power wire. most people worry more about which amp and what sub and how many rms, but if you dont have a good quality rca to deliver the input you've shot yourself in the foot. Dont cheap out on the wires.

Nice cables

These are high quality cables that help to clean up and simplify installation. Work excellent with stacked amps but could be problematic if you have amps mounted far away from each other.

Good product

I have been running these RCA's for 3 years now and still work perfect. Originally I ordered this set cause I was running a Rockford 5 channel. I just recently ugraded my system to a much larger system ( 4x the power) and decided to try these RCA's again. I have absolutly no noise in my system! I had some with the previous, but I think it may have been a ground. Only complaint, is that the junction point is pretty close, so hard to run my pac lc1 gain knob. Will end up ordering the two channel version of these.

Good sound quality but loose rca connections

I changed from cheap RCA cables to this monster cable. I was trying to get rid of noise coming from electrical system. It did that but was getting intermittent noise. Turns out the rca cables were not tight. I used a pair of pliers to tighten one of them and broke the end of the connector when barely bending it. May have been my fault, but it was a problem.