Platinum Digital Battery Terminal w/ One 1/0 AWG, Two 4 AWG & Two Screw Terminals for any AWG Wire
• Platinum Digital Battery Terminal
• Two 4 Gauge Outputs
• One 1/0 Gauge Output
• Two any gauge cable inputs w/ Ring Terminal
• Protective Cover Included
• 3-Digit Digital Voltmeter Display
• Screw Terminals Hold Cables Securely
Internal Product ID:
36367
Love it.
I can keep an eye on my voltage and have all my wires secure.
34
found this helpful.Xscropion DBT024RP
Nothing fancy about this terminal but it is not the worst.
Pros: solid piece of alloy that is platinum plated for very good signal transfer. Love the two any gauge ring terminals & also the 1/0 n two 4g inputs. Sturdy compression tightening that holds well. My only complaint is the phillips screw down. Would be so much better if it were allen wrench set screw. Also the display dont seem to work if you tighten it too much. Watever that is about. Other than that, does its job and is set at a very competitive price. Would buy again if i needed another one. Recommend for those "on a budget install"
34
found this helpful.Great Value
Looks very nice in the hood with led voltmeter. The material is very good. it's has many options in wiring. I recommend it.
32
found this helpful.Great battery terminal
Very nice terminal. Screen for voltage is very nice to have. Excellent quality. The screen is accurate within .2 volts usually.
30
found this helpful.Great
Looks and works great used this with my optima battery and big three upgrade. Digital meter works perfectly.
28
found this helpful.BatteryReplacementdigitaltvoltreadingerminal
Works, reads good ,advertised good , different sized hex head and flat Phillips head screws 3 different I thought a little odd, but terminal had no directions at all not even picture of how it should be installed or work? Not sure if digital reader ground wire should be hooked up constantly or just when u want to know voltage? Ground wire a short and may drain battery if hooked up 24/7 not sure how supposed to hook up permanently? Great product and service though, would buy again here and happy with overall experience !!!!
28
found this helpful.Good product
Good product. Makes it easier to install wires. Looks really good combined with the ground terminal an the Xscorpion AGU48P fuse holders.
27
found this helpful.worthless
I purchased this product from a different distributor. Not Sonic Electronix and the 1st arrived DOA, I got that replaced immediately. The 2nd arrived and worked all of a week. This has to be a manufacturer defect. I bought this solely because I run the big 3 plus I have other 4 gauge running. As far as hooking multiple cables this is perfect. Just don't expect a readout from digital LED. I have went to knuconcepts triple 0 gauge battery positive post and threw! This is in a box for a possible distribution block lol.
28
found this helpful.I like it
Great clamp that has a lot of hook up options. This is the only battery clamp I could find that allowed 2 1/0 ring terminal and also 2 four gauge as well and it still has another hook up.
It doesn't have a crystal clear plastic cover as described and I still cant figure out why you would have an active volt meter running under your hood where you wont see it 99% of the time. I hooked it up once to see it run and that was it.
I bought this off eBay from sonic for a dollar or so cheaper.
I would defiantly recommend this to anyone trying to stretch their car audio funds. You probably wont have to purchase another clamp down the road as this is very versatile.
28
found this helpful.digital terminal
great terminal overall..wish the terminal opened up a lil more to go over my post better but i just took a flat head screw driver and opened it up more...but works fine so far....good buy for price.
25
found this helpful.Best selling similar products