Customer Ratings & Reviews

best 4ch

I bought this amp and for a 4ch amp it rocks. Am using one Pioneer dvc 10" and two mid bass on my doors and two at the back dash and this little amp rocks my whole system. The bass is deep and the mids are clean and loud. My friends can`t believed it's one amp doing all that damage. I will say go with this if you have a low budget.

ok

I bought this amp with a grain of salt after reading reviews of Autotek, only to find out that Maxxsonic now owns them.
This amp is cheap so dont expect much when running 4 channel. (even at 2.6 ohm per) Its not much past deck power to 4)- 6.5" Kappas with 12 ga wire. Nowhere near the maxxsonics "MAXX" power, Im thinking around 40 watts rms, much higher then that and its distorting. 4v going into the rcas but the output rca is 2v.

For giggles i Bridged to my 2 12" subs and they barely hit compared to the RE amp that is rated at 1/3 the 4ohm x2 load. My guess is around 80-90 watts per channel nothing near the claimed "Bridged, 4 ohms: 600 watts x 2 chan".

This amp looks very similer to US/RE amps but acts nothing like them and I should have spent $30 more and got the US/RE 4 channel. The terminals are small so expect to hunt for connectors to fit the small screw terminals or solder wire ends.

Well worth the Price

I have this amp in my S10 on two 4x6s, two 6.5s, and two Autotek 6x9s! The little amp is playing at 2ohms on two channels 4ohms on the other two. The amp has never gone into protection. Never overheated, even though it is not in the most vented area. It is soo much louder than factory and plays very clean! The install was easy and it has a lot of nice features. I highly recommend it to someone looking for an amp in this price range! I'm thinking its about 45wrms per channel at 4ohms! Great Buy!!!

awesome

Very good amp. I have it running 2 12's. Superb bass. Very deep.