Marine & Powersports Deals

Single DIN: 1 DIN dimensions will work with all single DIN installation kits we have to offer. Single DIN radios are the most common size for after-market stereos.

Single DIN slot with flip-out screen: The DIN stereo includes a retractable, flip-out screen. Before purchasing, make measurements to be sure there is no interference with dash accessories such as A/C vents or shift levers.

Single DIN slot with a larger face: Standard single DIN size, but the display is larger then the standard single DIN size. Due to the nature of the larger face, problems may arise when installing in particular vehicles. These stereos are great for single DIN slots where you want a larger screen.

1.5 DIN: This size is very uncommon in vehicles, however this size opening is most commonly found in Chrysler and Chevrolet vehicles.

Double DIN: Approximately 4-inches in height, this size is becoming more common every year. Prior to 2000, this size was typically only found in Japanese vehicles such as those made by Honda or Toyota. Now, it is becoming more popular for many vehicles to be fit with a Double DIN opening.

RCA Composite Inputs
These are your typical red, white, and yellow RCA composite cables that are common among devices with audio and video inputs. The red and white cables are dedicated for audio. The red cable is for the right channel and the white is for the left channel. The yellow cable is specifically for the video signal. Because this type of auxiliary cable contains 2 channels of audio, it will support stereo sound.

3.5mm
This is commonly referred to as a mini-jack or a headphone jack. It is a 3.5mm plug that transfers audio only. There is a right and left audio channel on the plug which allows for stereo sound playback.

3.5mm AV Input
These plugs look similar to the common 3.5mm mini-jack, however they carry a third channel dedicated for video.

Optional
This means that an auxiliary input is possible, but only with the use of an optional accessory. These optional adapters will sometimes use the CD Changer port or other port on the back of a unit that might restrict the use of other expandability features. These accessories are typically sold separately.

If "Yes", then the aftermarket stereo is compatible with steering wheel remote controls. If an additional accessory is required for the steering wheel controls to work properly, a compatible piece will be listed.

An amplifier increases the power of the signal being fed to it by taking energy from its power supply and matching the signal but increasing its amplitude. Amplifiers use many different methods for converting these electrical signals and have been categorized into classes.

Class A/B: Greater than 50% of the input signal is amplified while the other percentage is “off”. These amplifiers have a small amount of current flowing through the output transistors all the time which almost eliminates crossover distortion. Class A/B has great sound quality but is not as efficient as class D. These amps are most commonly used to drive speakers.

Class D: Also known as switching amplifiers, class D amps have output transistors that are completely turned “on” or “off”. This means that when the transistors are on, there is almost no voltage across them but when they are off there is significant voltage but no current flowing through it which makes these amplifiers very efficient at the cost of sound quality. These amps are most commonly used to drive subwoofers.

RMS power is the amount of continuous power, measured in watts, that an amplifier produces is called RMS power. The higher the RMS figure, the louder and cleaner your music sounds.

The RMS output figure is much more accurate than the peak rating when comparing products.

Round/Circle: This is the typical and common subwoofer design. They have a round cone and are a circle in design.

Square: These woofers are able to achieve a greater cone area in a smaller space. Because of the greater surface area, some square subwoofers will be louder than a round subwoofer of the same size.