PAC SWI-CAN

The SWI-CAN module must be used with an optional Steering Wheel Interface module like the SWI-X, SWI-ALP, SWI-PS or SWIECL. The C2R-CHY interface module is recommended but is not needed. If you do not need an C2R-CHY interface, you can hard wire the SWI-CAN to any aftermarket vehicle harness. Wiring information on the SWI-CAN can only be obtained from our website. The SWI-CAN is a necessary interface for vehicles with SWC Controls that broadcast on a dual wire CAN Bus. This module can interpret CAN Bus messages and convert them to an analog output.

• Add-on module for use with SWI-X, SWI-PS, SWI-JACK, and SWI-ECL2
• Used when the factory steering wheel controls utilize the dual wire CAN Bus to control the factory radio
• Interprets the CAN Data to a usable signal that the other SWI-modules can use
• Connects to C2R-CHY or C2R-CHYNA for an easy all in on radio replacement
• 1-year Manufacturer's warranty

• Audi:
• 2002 - 2007 A4
• 2002 - 2005 A6
• 2002 - 2007 RS4/S4
• Chrysler:
• 2005-up Chrysler 300C
• 2008 PT Cruiser
• Dodge:
• 2007 Aspen
• 2006 - 2007 Dodge Caliber
• 2006 - 2007 Dodge Magnum
• 2006 - 2007 Dodge Ram
• 2006 - 2007 Dakota
• 2006 - 2007 Charger
• Jeep:
• 2005 - 2007 Jeep Grand Cherokee
• 2006 - 2007 Commander
• 2007 Compass
• 2007 Patriot

Check the Steering Wheel Interface Application Chart for CANbus Vehicles