MB Quart 5-Channel, 6-Channel & 8-Channel Amplifiers at Sonic Electronix

MB Quart 5-Channel, 6-Channel & 8-Channel Amplifiers

Filters
Why Shop With Us?
Loading...
Filters

An amplifier increases the power of the signal being fed to it by taking energy from its power supply and matching the signal but increasing its amplitude. Amplifiers use many different methods for converting these electrical signals and have been categorized into classes.

Class A/B: Greater than 50% of the input signal is amplified while the other percentage is “off”. These amplifiers have a small amount of current flowing through the output transistors all the time which almost eliminates crossover distortion. Class A/B has great sound quality but is not as efficient as class D. These amps are most commonly used to drive speakers.

Class D: Also known as switching amplifiers, class D amps have output transistors that are completely turned “on” or “off”. This means that when the transistors are on, there is almost no voltage across them but when they are off there is significant voltage but no current flowing through it which makes these amplifiers very efficient at the cost of sound quality. These amps are most commonly used to drive subwoofers.

Other Classes: You may see classes such as GH, bD, X, FD, etc. by some manufactures. These amplifiers tend to be either class A/B, D or a hybrid of the two but with improvements to their designs that can make them more efficient or offer better sound quality.

Each channel on an amplifier will power one speaker using a positive and negative cable. There are various types of amplifiers, each designed to power a certain number of speakers. Monoblock amplifiers, also known as single channel, are designed to power one or more subwoofers. These amplifiers often have very high power ratings. On the other hand, multi-channel amplifiers power multiple speakers, usually at lower power ratings. 2-Channel and 4-Channel amplifiers can power car speakers or low powered subwoofers. Occasionally you might see a 5 or 6-channel amplifier that can power speakers and subwoofers at the same time. The most common setup is a monoblock amp to run subwoofers and a 4-channel amp to run door speakers. Check out our Knowledge Base for more information.
Total RMS power is measured by multiplying RMS power per channel by the number of channels, and is calculated at the lowest level of operating impedance.

RMS power is the amount of continuous power, measured in watts, that an amplifier produces is called RMS power. The higher the RMS figure, the louder and cleaner your music sounds.

The RMS output figure is much more accurate than the peak rating when comparing products.

The total peak power output is measured as the wattage per channel multiplied by the number of channels, and is calculated at the lowest level of operating impedance.

It is measured during a brief musical burst, such as a sudden drum accent. Some manufacturers display peak power ratings on the face of their products to increase the appeal.

The RMS power rating is more accurate, and we recommend using it for product comparison.

The lowest impedance the amplifier will handle when it is not bridged.
If the amp comes with a bass/gain remote you will be able to control the level of your bass from your dashboard. Typically bass remotes also include a 16-20 ft. wire for installation.

A crossover is a type of filtering system that permits only certain frequencies to play. A Low-Pass (LP) crossover allows only frequencies below its setting to get through which is good in the case of some subwoofers. A High-Pass(HP) filter allows frequencies above its setting to pass through, this is normally used on speakers.

When a crossover is set to FULL it means no filtering is added and the full frequency spectrum is allowed through the amplifier. Filtering is important because feeding a speaker frequencies it cannot reproduce effectively creates distortion.

Speaker level inputs are commonly referred to as high-level inputs and vice versa. This input type allows you to get your audio signal directly from the speaker wire in your vehicle, instead of using RCA cables. The advantage of this is factory integration, as most stock radios do not have RCA outputs to run amplifiers.
This is the largest gauge wire that will fit into the power and ground terminals of this device. The lower the gauge number, the thicker the wire is. For example, a 4 gauge wire is thicker than an 8 gauge wire and thus has higher current carrying capacity. Always do your best to get this size wire to reduce the risk of damage to your components.
This feature will tell you if the amplifier has the capability to connect to a Bluetooth device.
listview icon
gridview icon
MB Quart FA1-900.5

FORMULA Series 5-Channel Class A/B + Class D 900 Watt Amplifier

FA1-900.5 main
Go to item page

FORMULA Series 5-Channel Class A/B + Class D 900 Watt Amplifier

• FORMULA Series 5-Channel Class A/B + Class D Amplifier
• 500W x 1 @ 1 ohm (Channel 5 only) / 100W x 4 + 350W x 1 @ 2 ohms / 60W x 4 + 250W x 1 @ 4 ohms
• DC Signal Sense
• FLUID-FETS
• Heavy duty heat-sink efficiently moves heat from the MOSFET
• Bass Boost: 0-12dB

2
MB Quart FA1-900.5

FORMULA Series 5-Channel Class A/B + Class D 900 Watt Amplifier

In stock

$299.99 (16.67% off)
$249.99
More info Item page
2 Special offers
  • Get A Free $50 Gift Card With Purchase!
  • FREE 4 Gauge 5/6 Channel Wiring Kit with Select Amps!

Item Added to Cart

FA1-900.5 small

FORMULA Series 5-Channel Class A/B + Class D 900 Watt Amplifier

$249.99

Keep Shopping

NVX XKIT46 4-Gauge 6-Channel Wiring Kit

6-Channel 100% OFC Complete True 4 Gauge Amp Kit with RCA Cables and Speaker Wire

$119.99

Add
NVX XIV65 V-Series Interconnect Cable

5m (16.40 ft) 6-Channel RCA Audio Interconnect Cable

$34.99

Add
NVX XWS1225 12 AWG Speaker Wire

25 ft. of True 12 Gauge 100% Copper EnvyFlex Speaker Cable/Wire

$29.99

Add

Don't see the accessory you're looking for?
View all available accessories for the MB Quart FA1-900.5.

Related Categories


MB Quart Car Subwoofers MB Quart Car Subwoofers

Browse our selection of 12-inch, 10-inch and other popular car subs in here. You'll also find various sub boxes and loaded enclosures, including ones made specifically for your car.

    clear all items