Dynamat Xtreme Bulk Pack 10455 - Open Box, Acceptable Condition Used

	Best Bang for Your Buck!
	NVX SDBP40	Dynamat Xtreme Bulk Pack 10455
Application: Entire Car
Vibration Dampener
Sound Absorber
Increased SPL Improved Sound Quality Reduced Distortion
Amount	40ft.2	36ft.2
Thickness	2.3mm	1.7mm
Dimensions	Ten 18" x 32" sheets	Nine 18" x 32" sheets
Sale Price	$99.99	$159.99

Dynamat Xtreme 36' Bulk Pack

Dynamat Xtreme is a patented, lightweight elastomeric butyl and aluminum constrained-layer vibrational damper. The Xtreme Series adapts and conforms easily to sheet metal and other hard metals vehicles are made of. This material works best for temperature ranges between 14° – 140° but can withstand ranges between -65° - +300°.

Cross Comparison Chart

	Dynamat Xtreme	Stinger RKX36B	NVX SDBP40	Ballistic SSBK	Cache CBM
Amount	36 ft.2	36 ft.2	40 ft.2	36 ft.2	40 ft.2
Application	Entire Car	Entire Car	Entire Car	Entire Car	Entire Car
Thickness	1.7 mm (67mil)	2.0 mm (78.75mil)	2.3 mm (90.55mil)	2.1 mm (82.68mil)	2.2 mm (86.61mil)

Xtreme Applications

The Dynamat Xtreme Bulk Pack is great for improving the overall sound quality in your vehicle by cutting out unwanted road noise. It is typically used on vehicles to reduce vibrations and rattles on rear decks, doors, floors, trunk floors, trunk lids, roofs, quarter panels and under-hood installations. This kit comes in nine 18" x 32" sheets combining for a total of 36 square feet which should be plenty for any of the trouble areas in your vehicle.

Easy to Install

Use scissors, a knife or a die to cut the Xtreme to the desired size and shape before removing the release liner. Next, remove dust, grease, moisture, and other foreign matter from the application surface. Now it’s time to peel off the release liner and start applying. The easiest way to apply is to bend the mat slightly and attach it along its shortest edge. Using a roller, press the mat tightly into place, the roller will help eliminate unwanted air pockets. There is no need for heating the material, for best results the application surface should not be below room temperature.