700W Peak 350W N-Series V2 10" Dual 4-Ohm Car Subwoofer
• 350 Watts RMS / 700 Watts Max
• Impedance: Dual 4-Ohm
• Ultra-Light Non Pressed Paper Cone
• Custom Blended Foam Surround
• 2” High Temperature Aluminum Voice Coil
The NVX N-Series subwoofers offer top-notch sound quality at an entry-level price. The NSW104V2 is a great multi-purpose sub that has been engineered to meet the highest audio standards. The stiff, ultra-light non pressed paper cone allows the N-Series subs to give you accurate and responsive low-end even when you have your system blasting. The custom-blended high roll foam surround allows for greatly improved excursion for further improved sound quality. The 2" dual 4-ohm high-temperature aluminum voice coil gives you a wide array of Ohm load wiring options for different applications. With an RMS Power Range of 200-350 watts, the NSW104V2 requires less power to operate efficiently without losing bass quality.
Continuing with the excellent engineering is a stamped steel basket that provides exceptional rigidity while minimizing any unwanted distortion. The N-Series subwoofers also include spring-loaded, chrome-plated push terminals that provide an easy and secure speaker wire connection. NVX's mission was to create an exceptional subwoofer at an entry-level price without sacrificing the quality and sound that the consumer deserves. They have succeeded!
We’re all about the details here at NVX. That's why we include a rubber trim ring gasket with our N-Series subwoofers. The trim ring provides a tight seal against the sub and the box it is being mounted to, in order to prevent air pressure from passing between the two.
We’re all about getting the most bang for our buck, a key reason why we chose to include high-roll foam surround technology in the N-Series woofers. The surround itself is constructed with high excursion foam, which keeps the inward movement of the surround perfectly symmetrical with the outward movement.
Our custom basket offers several distinct advantages over traditional designs. We purposefully chose an especially open basket to improve airflow to reduce compression of the motor structure for both improved cone control as well as reduced back-wave interference.
The stout 2" high-temperature voice coil is constructed from a copper wire wrapped around an aluminum former. This industry-standard design is powerful enough to readily drive the cone with strict linear control, yet at the same time remains efficient enough for the compact, space-saving magnet structure.
We chose a highly magnetized single stacked Ferrite magnet for the motor structure in the new N-Series. This magnet allows for greater power handling and voice-coil control during high excursion limits.
After testing scores of different cone materials, we decided on a custom blend of fine Ultra-Light Non-Pressed Paper fibers. This stiff yet lightweight material produces spectacularly accurate bass with a rich, natural tonal quality prized by audiophiles. The smooth matte finish of the cone offers a sleek, modern accent to the interior of any car.
At NVX we understand that the components of a subwoofer must work in harmony to achieve sonic excellence and that a subwoofer is only as reliable as its weakest link. There is perhaps a no better example of our relentless attention to detail than the unique attachment method of our tinsel leads. Whereas the leads of most subwoofers are simply glued atop the spider, ours are glued at the basin of each fold in the spider with enough slack on top for an unrestricted excursion.
We didn't even skimp on the magnet boot for our N-Series subwoofer. Besides looking better than a bare magnet the rubber boot protects the magnet from chipping and possible corrosion that can affect magnets exposed to the elements.
NVX NSW104 Version 2 (NSW104v2)
700W Peak 350W RMS N-Series V2 10" Dual 4-Ohm Car Subwoofer
Single 10" Sealed 3/4" (1.2 cubic ft) MDF Black Carpeted Subwoofer Enclosure (Made in the USA)
(newest, current model)
(previous model, replaced by NVX NSW104V2 + NVX XMDFS101 Sealed Single 10" Subwoofer Enclosure)
Internal Product ID:
I'm running 3 of them in a sealed box, Hifonics 1600.1 Brutus Class D. Both from Sonic. Still braking them but they sound awsome, good sql. Very happy, getting a lot of thumbs up. Thanks again Sonic
I believe these are the most slept on subs on the market holy crap!!!, These things hit harder then a Rockford Fosgate p3 I used to have!, I only have one and I'm pushing about 400 rms to it off an alpine PDX amp and it hits hard!!! People come down from there houses when I'm double parked to tell me to lower my music!!, My full setup is alpine type s components front and back, an audio control ic7 to run the amp off my factory radio, and just one alpine pdx v75 shout out to alpine this amp is a beast it powers my whole system!! And last but not least this nvx 10 sub along with an SPL cap my system sounds awesome clear and loud!! Please don't sleep on these subs they hit harder then subs that cost twice as much and sound quality is on point!!
Good sub, great sound, sexy look, and it can take a beating.
This sub hits hard ands sound great doing it. I have 3 wired yp on a kicker 600.1. They sound great. If you want sone good tite bass grab you a set.
Crazy for entry level subs
I bought 3 thinking it would be weak.. I should have only bought 1 or 2 LOL beastt.
Tickled to death with ths sub and Belva (with the polished black front) box combo. I had 2- 12" Kenwoods running off of a Fosgate P300.1 amp and they sounded great but in my 06 Mustang GT my whole trunk was occupied. I wanted to downsize and after many days of looking I caught this sub on sale and thought I'd give it a go.. I just wish now that I would've got a 12" because this sub is amazing. Try it if your considering it, great quality, unreal lows and with a beefier amp I'm sure it'd be that much better. Great sub!!
Nvx 10" sub
I was looking for a sub for a decent price. I found this NVX on sonic electronix web site, it had great reviews.So I figured I would give it a shot.Shipping was quick. I put this sub in a
sub zero vented box I had with an amp rated 370rms. This thing bumps great especially for the price. I also tried this sub in a seal box that I had to see which preformed better. I would say this sub was meant for a vented or ported box.The sound of this sub in a seal box was pretty good. But for my application the vented box sounds way better.
These are Great
These are great. Running 2 of them free air right now until i get my enclosure and they sound phenomenal. Planning to buy 2 more.
Very low hitting bass
This sub surprised me as soon as i pluged it in very low bass amazing sound quality on a budget
Great buy sub
This sub sounds great with my Kenwood class D amp. Works well with mid and lower tones. Didn't break the bank either.
This product is temporarily out of stock. May we recommend...
• Sealed downward-firing enclosure with one CompRT 12" subwoofer and passive radiator
• 3/4" medium-density fiberboard construction covered with carpet
• 2-ohm total impedance
• Power Handling: 500 watts RMS (1000 watts peak power)
• Sensitivity: 98 dB
• Frequency Response: 25-500 Hz
• Dimensions: 27-1/2"W x 14-5/8"D x 6-1/8"H
• 700 watts Watts Peak
• 350 watts Watts RMS
• Carbon Fiber Reinforced Polypropylene Cone
• Butyl Rubber Surround
• Includes Depth Extension Clearance Plate
• Includes Sealed Enclosure
• 12" Solo-Baric Subwoofer in Thin Profile Enclosure
• RMS: 600W / Peak: 1200W
• Square Sub Design Moves 20% More Air Than Round Subwoofers
• Easily Mounts Under or Behind a Seat
• Advanced internal bracing
• Ribbed Santoprene Surround Resists Heat And Degrading
• 400 watts Dual 12" Sealed Subwoofer Enclosure
• Single 4 ohms Impedance
• Spring-loaded Terminal Posts
• Enclosure Dimensions: 11-1/8" TD x 13-1/2" BD x 29-11/16" W x 14" H
• Single Square 12" Subwoofer Enclosure
• Forced-Air Cooling
• Enclosure Dimensions: 11 1/16" TD x BD x 12 5/8" W x 4 1/8" H
Save up to 10 different vehicles in your garage