500W Max (250W RMS) 12" Prime Stage 2 Dual 4 ohm Subwoofer
• Peak Power: 500W
• RMS Power: 250W
• Mica Injected Polypropylene Cone
• StampCast Basket
• Anodized Aluminum Voice Coil Former
• Frequency Response: 43-250 Hz
• Includes Ported Enclosure
• Peak Power: 500W
• RMS Power: 250W
• Mica Injected Polypropylene Cone
• StampCast Basket
• Anodized Aluminum Voice Coil Former
• Frequency Response: 43-250 Hz
• Includes Ported Enclosure
Prime subwoofers are ready to rock and are the perfect first step into performance audio.The Prime R2 12" subwoofers have a peak power rating of 500 watts and a continuous RMS power rating of 250 watts. This makes them an ideal subwoofer for anyone looking to add some modest low end to their car audio system. The Prime R2 drivers feature an anodized aluminum voice coil formers for extreme heat dissipation that allow the driver to perform at optimum level during long hard hitting sessions. These subwoofers are the way to go when looking for a woofer that is built with quality & performance in mind and has been designed by industry's leading car audio manufacture.
These woofers, like their Punch brethren, are built using many of the same speaker technologies that Rockford has been famous for over 30 years for and you won't break the bank buying one. Simply put, the Prime seriesof woofers are held to the same standards of quality and performance as any other Rockford woofer but delivered at an affordable price.
Anodized Aluminum Voice Coil Former
By using an anodized aluminum voice coil former on their subwoofers, Rockford Fosgate is able to dissipate heat from the voice coil more efficiently. A hot voice coil can melt the adhesive bonds, which will lead to eventual subwoofer failure. The aluminum voice coil former acts as a heat-sink to dissipate thermal build-up on the voice coil cool during high SPL conditions.
Conforms to CEA-2031
Rockford Fosgate has built this subwoofer to conform to the CEA-2031 loudspeaker power handling industry standards. This means that you can trust the subwoofer to have the capacity to safely handle the continuous (RMS) power rating. Having a CEA-2031 power handling is important when matching a subwoofer to an amplifier because the power ratings are accurate.
Stitched Tinsel Leads
To improve the reliability and performance by reducing fatigue and possible shorting, Rockford Fosgate has stitched the tinsel leads to the spider. The multipoint periodic stitching lead wires reduce the mass of the tinsel leads to spread the stress over a greater area. This improves the reliability and performance of the subwoofer.
Rockford Fosgate Prime R2D4-12
500W Max (250W RMS) 12" Prime Stage 2 Dual 4 ohm Subwoofer
Quantity: 1
Priced Individually
Single 12" Vented MDF Subwoofer Enclosure (Belva 1SV12B)
12-inch Vented Car Sub Box Made with 3/4" MDF and lined w/ Polyfil (1.8 cu ft airspace 1SV12B)
Quantity: 1
You've got an awesome subwoofer there, pal. But where's it gonna go? You can't just throw that thing in the trunk and call it a day. Don't worry, Belva's got your back. With superior construction, great features and everything you need for bass, you'll be ready to pass up that entry-level box you've been eyeballing.
You get quality boxes with solid 3/4" MDF because nothing else will do the job right. You want to flex your windshield, not your box's innards. You get polyfill built into the box, making sure your subs perform perfectly. On top of that, you get a box that's CARB Phase 2 Compliant, meaning your box won't emit as much nasty formaldehyde as the competition. Better for your bass and better for you.
![]() |
Look, nobody buys a subwoofer and says, 'Aw man, I just want a teeny bit of thump.' Naw man, you want something that kicks you in the chest, but you need a box that's gonna put up with it. That's where Belva comes in. While other brands use less-than-optimal 1/2-inch MDF, we've got 3/4-inch MDF to make sure you get all the bass you can handle. Why risk a busted box? Belva's the obvious choice when it comes to giving your sub a good home and giving you the low end you're looking for. |
![]() |
Manufacturer:
Model Number:
R2D4-12, 1SV12B
Weight:
45.00lbs
Internal SKU:
r2d412_1sv12b
Internal Product ID:
199185
good
Pretty well made box. The sub hole was a little too small for my 12" hcca but a little cutting solved that. I didn't have time to make my own box so this suited me realyl well.
96
found this helpful.good product
Sound really good and looks good. Made fairly good. Would for sure recommend
94
found this helpful.Very very nice, exact specs below.
Very nice box. The carpet is nice and seems to be glued properly, although it does look like it might rub off in time. Build quality is very nice, feels very sturdy. There are some globs of dried glue on the exterior but nothing I can't get over. It would have been nice to not have the sub cutout so close to the port but that's just nitpicking. Doesn't come with wires internally but the terminals are much nicer than I've seen on other prefab boxes.
Regardless of what Belva has published, this box is not 1.8 ft.
The gross volume is 1.97 ft, but after taking into account port displacement, it's net volume is 1.30 ft. It's also tuned to 34.4 Hz. Determined using the Torres Speaker Box Calculator.
86
found this helpful.Not bad
So I bought one of the "Sonic Boxes" a couple years back and it was similar to this box but gray. The sonic box was better build quality. This box has a hole cut that is nowhere near center. It's up and to the right a bit, but that's what you get for a 55 dollar box I guess. The carpet around the ported has started to come unglued and the box hasn't had any play time what so ever. It seems to be mdf and 3/4". The dimensions are correct. Port tune is around 35 hz and net box size is around 1.4 cubic ft. The poly fill probably needs to be glued down so I will stay inside the box. The port used to be rounded on the inside with the sonic box now it is not. It is a good box to get by on since it is built pretty well, but I would recommend getting a box built to spec for the woofer you have for optimal sound. For 55 bucks it's not a bad way to get by, just don't expect the best for that price point.
83
found this helpful.well built box
For the price it cannot be beat. This box meets the recommended size enclosure for the single sub i ordered, which is the Rockford P2D4. Ported to trick the sub its in a bigger box with poly fill lining. Well built and carpeted in dark gray. I highly recommend it. Hits lows hard and loud.
86
found this helpful.Great Prefab box
I would highly recommend this box it sounds like it is tuned between 34-36hz hits lows really good unlike i was expecting since it is vented. I had a rockford fosgate p3 and it sounded amazing in the box and now I have an Alpine type S in there until my new p3 comes back in and the type s even sounds great i didnt think a type s would pound like it did. Good box would def recommend and buy again if need be.
79
found this helpful.Awesome box
This box sounds great coupled with a Pioneer Champion Series Pro and 1500 watt amp. Very deep bass tones and very loud. Definitely would recommend.
79
found this helpful.Worth the space
I downgraded from a much larger box to this one and noticed no difference. Saved me some space, though it's still pretty big, and handles the sub perfectly. Feels sturdy and looks good.
81
found this helpful.Belva
This cost more then the gray one but they both perform the same just that the black exterior looks way better then the gray
79
found this helpful.Great product
Slim and powerful speaker that packs massive power for a great price.
80
found this helpful.Best selling similar products
Rockford Fosgate Punch P3-2X12
• Dual Punch P3 12" Loaded Subwoofer Enclosure
• 2400W Peak
• 1200W RMS
• Constructed with Durable 5/8" MDF
• High Current Binding Posts
• Durable Black Carpet Covering
• Computer Optimized Design
• 1 Ohm Final Impedance
(34)
$659.99
• Low Profile Ported Subwoofer System
• 200 Watts RMS
• Built-In Class D Amplifier
• Variable Bass Boost
• Speaker-Level Inputs
• Wired Remote Bass Level Control
(15)
$149.99
• Low Profile Ported Subwoofer System
• 150 Watts RMS
• Built-In Class D Amplifier
• Variable Bass Boost
• Speaker-Level Inputs
• Wired Remote Bass Level Control
(4)
$109.99
• Dual 12" 12W0v3-4 Loaded Ported Enclosure
• 1200W Peak
• 600W RMS
• Top-Quality MDF Construction
• Durable Dark Gray Carpet Finish
• Five-Way Binding Post Connectors
• Embroidered JL Audio Logo
(11)
$499.99
• 750W Single 12" Ported Subwoofer Enclosure w/ Multi-Color LED and Remote
• RMS: 300W
• 4 ohms impedance
• Ported enclosure with black carpet and embroidered Belva logo
• Angled-back ported enclosure
(4)
$89.99
Save up to 10 different vehicles in your garage