Car Alarm Sensors, Triggers & Relays

• Audio Sensor That Detects Attempts to Tamper with or Break Your Vehicle's Glass

• Dual Zone Proximity Sensor
• Dual zone sensing
• Protects both inside and outside of the vehicle
• Each zone is independently adjustable
• LED sensitivity test light
• Pre-wired 4-pin plug allows easy connection to all Omega systems

• Mercury Tilt Switch
• Detects Open Zones
• Waterproof Design
• Adjustable Angle

• 5 normally closed trigger inputs
• 1 negative trigger output

• GPS Antenna Included
• Bumper Radar Sensors with built-in Control Unit Installation
• IPX6 and IPX7 Rating
• Blind Spot Reading Accuracy
• Blind Spot’s Effectiveness

• Automotive 40/30 Ampere Relay

• OEM Alarm Shock Sensor Upgrade Kit
• Allows factory alarm systems to detect impacts to the vehicle
• Designed to interface for factory alarms extra sensor input

• Stinger DoubleGuard Shock Sensor
• Adjustable Sensitivity
• Wire Harness Included

• Invisibeam® Field Disturbance Sensor
• Generates two invisible detection fields around your vehicle
• Offers 2 response types

• Dual Zone Proximity Sensor
• Complete with Harness
• Compatible with Clifford G4 and G5 Systems

• Tilt/Motion Sensor
• Adjustable Tilt and Motion Sensitivity
• Adjustable Arming Delay
• Independently References Initial Vertical and Horizontal Inclination Each Time the Vehicle is Parked

• Ultrasonic Sensor for Security Systems
• Detects air pressure changes in the cabin of the vehicle
• Detect thieves entering vehicle without glass breakage
• Adds extra protection when used in conjunction with other security systems

• Solid-state, high current relay block
• LED Indicators

• Alternator RPM Monitor
• For Use With Remote Engine Starters or Security Systems
• Converts Spikes Into An Output That Simulates a Tachometer
• Detects Electrical Spikes

• Quantity: 5
• Variable Resistors
• Adjustable from 0 ohm to 5000 ohms
• Color; Grey and Black

• Detection Range: 1.6 m/5.2 ft
• Volume control/Mute ability
• Plastic bumper friendly
• Compatible with metal bumpers when used with included rubber sleeves

• Universal trigger output module
• Multiple trigger options

• 4-Position Switch Selects Desired Voltage Output
• 3.3V for some cameras as a replacement power supply
• 6V for OE reverse camera retention
• 9V for use with a wide range of devices that run on 9V

• Triangulation technology
• 2 or 4 sensor installation
• Low profile, paintable sensors
• Wide detection angle with minimal blind area
• OE sounding tone
• Self-diagnostic mode at startup

• Dual Zone Magnetic Shock Sensor
• Precise and Reliable Performance
• LED Indicators for All Three Zones
• Direct Plug Into any Omega Alarm