Scosche SU2027B / SU2027 Dash Kit

Fits Perfect

Fits perfect without any issues. Matches the other dashboard. Don't know what other people were complaining about. Very nice tight snug fitment.

It keeps my indash gps from falling out or moving around

The install kit was for a 2009 Subaru Impreza WRX and it does a great job of holding my Pioneer head unit in place. No complaints here.

Excellent kit

I have installed many head units and this is easily the best install kit I have come across. Very sturdily built, thick plastic. This kit is more versatile than the equivalent Metra alternatives, which I have read are flimsier and more "janky." That is why I decided to go with the Scosche, and I am very glad I did. Fits perfectly in my 2008 Subaru WRX (sedan).

Close to perfect fit

I bought this along with my new Pioneer double-din deck, to replace the stock stereo in a 2008 Subaru Impreza 2.5i. It fits pretty well, but the side screw slots that actually screw into the dash weren't perfectly aligned once connected to the new stereo, so i had to cut the holes a little wider. Nothing too serious. Overall, a great buy.

Great Look

Easy to use and looks great installed in the dash. Could be a little better if the side snapped in better. I had to use tape. Once sides screwed to radio, very steady. Did need pocket. Install was in 2009 Subaru Forester.

Works Well

Fitment works well, everything bolts up nicely. The only bad thing I have to say is that flush mount is not possible with the head unit I bought. The AVH-X5600 bottoms out before flush.

Install kit worked great

I ordered the install kit and I had it within 5 days, and it had everything I needed. Thanks!

Scosche SU2027B

Excellent product. Much needed after an after market stereo Install. I highly recommend this.

a perfect fit

highly recommended. replaced double din oem to single din Pioneer HU in MYO9 Forester easily, with using this surround and pocket.
pros
- surround is a perfect fit into the 8" dash hole.
- clean, dull, matte finish, seems to resist finger marks
- best value for money and easiest solution vs replacing with JDM fascia and other solutions

only cons
- premade to fit pocket at the bottom position only, for a single din install. easy to workaround by just drilling two 5mm holes, to fit pocket into top position. (i can kind of see why this was not done by Scosche, as they may perceive that it may slightly weaken the top support. though this isn't the case.)
- in a perfect world the pocket would be a little deeper and higher

if you have any issues lining up to the dash screw holes, just put a washer between the stereo and/or pocket, and the side mounting plates. that will increase the distance between the holes without needing to file or re-screw the dash screw holes. I'd imagine this is because of the minor differences in the width of stereo casings. (i needed to put a washer on either side of the pocket, but not the stereo, before attaching the side supports).

Perfect Fit

Looks like it belongs in the dash more than the stock stereo did.