See all parts that fit your 2011 9-5
High Power 2-Channel Line Output Converter with Low Voltage Trigger Remote Output
High Power 2-Channel Line Output Converter with Low Voltage Trigger Remote Output • Provides a low level trigger circuit for controlling an amplifier • Has 0.5dB Linearity from 20 - 20,000Hz
Learn more about the sni45tThe Pac SNI-45T can be used when adding an amplifier to a factory radio to convert the radio's speakers level output to the lower amplifier (RCA) level input. The SNI-45T uses audio transformers for noise isolation and is phase adjusted. Both channels are adjustable and reduces the radio output to the best amplifier input level. This converter is used for radio with 2-60 watts RMS.
Best selling similar products
Manufacturer:
Model Number:
SNI-45T
Weight:
0.50lbs
Internal SKU:
sni45t
Internal Product ID:
18107
PAC SNI-45T works great!
This product has been working great since I installed it in my 09' VW Jetta. Hooked into the rear speaker outputs at the deck, then ran to the trunk to the PAC.
No turn-on thump or turn-off crackle. Just plain old WORKS.
Highly recommended if you want to add subs to your factory system.
39 found this helpful
Handy
This little unit is very useful as it gives you a remote turn on signal without having to search for a 12 volt accessory wire. Great when your installing a sub and amplifier with an otherwise factory system!
38 found this helpful
PAC SNI-45T
Works great, easy to install
34 found this helpful
Good stuff!
Works great, clean sound. Ties into factory wiring with very little hassle. Remote turn-on to feed aftermarket amps made it painless to upgrade the factory system.
33 found this helpful
Cancel
Modern vehicles often require specific brackets, wiring harnesses, and mounting solutions. A fit guide ensures:
Whether you're replacing a factory stereo or upgrading your entire audio system, the Fit Finder eliminates uncertainty.