160W Peak (80W RMS) 6.5" 2-Way Component Speakers + NVX Speaker Baffles, Panel Removal Kit, Sound Dampening and Roller
Product highlights
• Peak Power: 80W
• RMS Power: 40W
• 1/2" Mylar Balanced Dome Tweeter
• Mounting Depth: 2"
• Mica Injected Polypropylene Cone
• 4 Ohm Impedance
• Sensitivity: 89dB
If you’re looking for sound quality at a fantastic value, the Rockford Fosgate PRIME series speakers are your calling card. Available in multiple sizes, the PRIME speakers are the perfect factory door speaker replacement if you’re not looking to spend a ton of money. They are designed with a polypropylene cone in order to provide a punchy sound with quick transitions from note to note. Rubber speaker surround assist with the linear movement of the cone while simultaneously allowing for a great excursion than many other speakers. The PRIME series speakers are designed with a shallow mounting depth and a wide frequency response for an easy fitment with maximum performance in almost any vehicle on the market. If you’re looking for the next big upgrade for your vehicles audio system, check out the PRIME speakers by Rockford Fosgate!
Rockford Fosgate PRIME R165-S
160W Peak (80W RMS) 6.5" Prime Series 2-way 4-ohm Component Speaker System
Quantity: 1
Priced Per Complete Component System: 2 woofers, 2 tweeters and 2 crossover networks.
NVX XBAF65
2 Piece 6.5" or 6.75" Weatherproof Silicone Rubber Speaker Baffle Kit
Quantity: 1
NVX SDBSK2 Premium Stealth Black
Premium Sound Damping (Sound Deadening) Speaker Kit, two 10" x 10" Sheets (91mil THICK)
Quantity: 1
NVX SDRLR2
Universal Professional Heavy Duty Roller for Sound Damping (Sound Deadening)
Quantity: 1
Five Piece Installer Panel Removal Tool Kit for Car Stereo/Audio (Belva BTK105)
Five Piece Installer's Panel Removal Installation Tool Kit for Car Stereo, Speakers and Car Audio Installs
Quantity: 1
Stop wrapping screwdrivers in electrical tape and hoping for the best. If you want to make your next installation smooth, and keep your interior immaculate, pick up a set of these Belva BTK105 Panel Removal Tools.
This set of nylon plastic tools make your job easier when it comes to pulling off those interior pieces, but it also keeps you from marring your finish. When you're done with the job, no one will know you ever pulled anything off in the first place. Make your next audio improvement a cinch with the Belva BTK105 Panel Removal Tools.
|
(newest, current model)
|
|
(previous model, replaced by Rockford Fosgate T2652-S with Speaker Installation Kit)
|
Best selling similar products
JBL STAGE1 601C (STAGE1601C) with Sound Damping
• 200 watts Peak Each, 40 watts RMS Each
• Mylar Balanced Dome tweeters
• Polypropylene cone material
• Impedance: 4 ohm
• Sensitivity: 90 dB
(45)
$67.99
List price $138.73
Alpine S2-S50 with Sound Damping
• 170 watts Peak Each, 55 watts RMS Each
• 3/4" Silk Dome Tweeters
• Polypropylene cone material
• Impedance: 4 ohm
• Sensitivity: 87 dB
(43)
$144.94
List price $178.74
JBL STAGE2 634 (STAGE2634) with Sound Damping
• 250 watts Peak Each, 40 watts RMS Each
• PEI (Polyetherimide) Balanced Dome tweeters
• Injection Molded Polypropylene - IMPP cone material
• Impedance: 4 ohm
• Sensitivity: 91 dB
(55)
$88.98
List price $118.73
Hertz MPK163.3 with Sound Damping
• 150 Watts Max Each, 75 Watts RMS Each
• Pressed-pulp cone with cotton fibers cone material
• Tetolon Tweeter Dome
• 4 Ohm Impedance
• Sensitivity: 92 dB
(43)
$1014.98
List price $1168.74
(4) Rockford Fosgate P1683 with Speaker Installation Kit
• 130 watts Peak Each, 65 watts RMS Each
• 3/4" PEI (Polyetherimide) Dome Tweeters
• cone material
• Impedance: 4 ohm
• Sensitivity: 90 dB
(123)
$230.47
List price $238.72
Hertz DCX165.3 with Sound Damping
• 120 watts Peak Each, 60 watts RMS Each
• 5/8" PEI (Polyetherimide) Dome Tweeters
• Water-repellent pressed paper cone material
• Impedance: 4 ohm
• Sensitivity: 93 dB
(43)
$144.98
List price $168.74
Pioneer TS-D69C with Sound Damping
• 330 watts Peak Each, 110 watts RMS Each
• 1" Polyester Fiber Soft Dome tweeters
• Aramid fiber reinforced Injection Molded Polypropylene cone material
• Impedance: 4 ohm
• Sensitivity: 86 dB
(41)
$194.99
List price $278.74
Hertz MPX 165.3 with Installation Accessories
• 200 watts Peak Each, 100 watts RMS Each
• 1" Tetolon Soft Dome Tweeters
• Pressed Pulp Fiber cone material
• Impedance: 4 ohm
• Sensitivity: 92 dB
(294)
$444.05
List price $547.71
JBL Stadium 62CF (JBLSPKSD62CFAM) with Sound Damping
• 330 watts Peak Each, 110 watts RMS Each
• 3/4" Aluminum Dome Tweeters
• Glass Fiber cone material
• Impedance: 3 ohm
• Sensitivity: 93 dB
(42)
$424.94
List price $458.69
Hertz C 165 F with Sound Damping
• 210 watts Peak Each, 70 watts RMS Each
• Semi-Pressed paper with Mica cone material
• Impedance: 4 ohm
• Sensitivity: 93 dB
(41)
$214.98
List price $248.74
Manufacturer:
Model Number:
R165-S, XBAF65, SDSK2, SDRLR1, BTK106
Weight:
12.81lbs
Internal SKU:
r165s_xbaf65_acc_kit
Internal Product ID:
195317
| 5 star |
|
84% |
| 4 star |
|
11% |
| 3 star |
|
4% |
| 2 star |
|
0% |
| 1 star |
|
1% |
| Durability | ||
| Value | ||
| Features | ||
| Design | ||
| Usability |
Apparently, one size does not fit all 6.5" speakers...
Unfortunately, I cannot give a review on the product's performance as I was unable to use it in the manner for which it was manufactured due to incompatible size issues. The speakers I have are the CVMPCL6.5 - 6.5" STROKER PRO 200W Midrange Gold Speakers. Pairing these speakers with the NVX XBAF65 Speaker Baffle Ring Kit spawned two issues:
1) The mounting depth for the baffles is 2-5/8" (2.625 inches), whereas the mounting depth for the speakers is 2.930 inches. This minor difference was seemingly insignificant until the second issue reared its ugly head.
2) The width of the baffles is much too small for my speakers. I can't seem to find information on the exact dimensions of the baffles as I have not yet contacted NVX. But the width (diameter) of my speakers is < 5.76 inches. This is obviously too wide for the baffle because the baffle would not go on without a fight. I pulled, tugged, stretched, and strained nearly damaging the speaker. I then decided to make a few modification cuts to the baffle to accommodate the sheer width of the speaker, but the result was a shredded baffle and a traumatized speaker.
Now I'm stuck with three unusable baffles because I bought two pair!
Regarding speaker width, the CVMPCL6.5 - 6.5" STROKER PRO 200W Midrange Gold Speakers have unremovable hardware tabs attached to them that I can only assume are there to somehow protect the speaker leads. They stick out from the speaker basket making it impossible to properly install the baffle and, in turn, causing the magnet to protrude out of the base of the baffle a lot farther than it would have if the baffle were wide enough.
Regarding the attached photos, the unmodified baffle from the first pair was used to demonstrate the issue.
Attachment: Photos
**** VENDOR RESPONSE ****
The XBAF65 are made for nearly all 6.5" speakers. The Cerwin-Vega pro midrange seem to be the culprit as their depth and basket are atypical.
We will do our best to come out with a new, larger "oversized 6.5" version and name it XBAF675. It will take us some time to tool and come out with it, but hope you enjoy the feedback.
Verified purchase
94
found this helpful.Foam vs Rubber
The best thing about these speaker baffles are the fact that they are rubber vs the easy to find foam. They definitely add a nice level of water resistance with the rubber. Not to mention the sound quality improvement. It's seriously a night and day difference. Trust me, just buy them!
85
found this helpful.Protect Your Purchase
I like these baffle rings because it gives that added protection for my mid-bass component from any water that may slip through the window sill. It also helps with reducing any unwanted vibration noise. The egg crate foam placed behind the speaker on the inner lining of the door helps absorb waves to add more decrease in vibration.
The silicone-rubber material is going to last a long time and can be easily trimmed for a custom fit.
Verified purchase
71
found this helpful.But them a must have
I makes sound project forward and also gives piece of mind of some possible water resistance........ A must have for better sound quality
Verified purchase
70
found this helpful.Sweet Speaks!
I replaced the OEMs in the doors of my 03 Tundra and was very pleased with the difference.
I am only driving these with my Sony (always excellent signal to noise ratio!) media head unit but they put out plenty of sweet and clean vibes!
74
found this helpful.Work good, good product
they work well. just make sure your on the spot before you stick the foam on because it is sticky.
68
found this helpful.absolutely perfect!
highly recommend for a clean speaker install. helps keep from losing mid-range sound.
Verified purchase
67
found this helpful.Helps doors
Great baffles to help the high powered door speakers bang
Verified purchase
66
found this helpful.Five Piece Installer Panel Removal Tool Kit for Car Stereo/Audio (Belva BTK105)
Good for the price, could be better, does what it’s supposed to
65
found this helpful.Decent
Pertty good speakers. They distort at high volume but have a decent sound at mid range. Worth the price!
71
found this helpful.
NVX SDBSK2 1.38 Square Feet Damping Kit
Eliminates speaker panel distortion and reduces vibration, rattles, and squeaks!
(41)
$14.99
List price $18.74
NVX SDSK2 1.38 Square Feet Damping Kit
Eliminates speaker panel distortion and reduces vibration, rattles, and squeaks!
(104)
$9.99
List price $18.74
NVX SDBPRO20 20 Square Feet Damping Kit
Eliminates speaker panel distortion and reduces vibration, rattles, and squeaks! (4.5mm Thick)
$109.99
List price $143.99
NVX SDBBP40 36 Square Feet Damping Kit
Eliminates speaker panel distortion and reduces vibration, rattles, and squeaks! (91mil Thick)
(38)
$114.99
List price $131.99
Eliminates speaker panel distortion and reduces door vibration, rattles and squeaks!
(47)
$39.99
List price $47.99
NVX SDRLR1 Sound Damping Rubber Roller
Universal Professional Heavy Duty Roller for Sound Damping
(116)
$10.99
List price $13.99
NVX SDRLR2 Sound Damping Rubber Roller
Universal Professional Heavy Duty Roller for Sound Damping
(18)
$11.99
List price $14.99
NVX 25 ft. of True Spec 16 Gauge Speaker Wire
100% OFC wire with EnvyFlex metallic jacket and noise eliminating twisted-pair technology to provide crystal clear sound.
(52)
$19.99
List price $29.99
Belva 23 ft. of True Spec 16 Gauge Speaker Wire
100% Copper Clad Aluminum and PVC blended jacket for easy installation and high strand count for maximum audio quality
(18)
$12.99
List price $24.99
Belva BTK106 Trim Panel Remover
Six Piece Professional-Grade Installer Panel Removal Tool Kit for Car Stereo/Speakers
(40)
$14.99
List price $19.99
Belva BTK105 Trim Panel Remover
Five Piece Professional-Grade Installer Panel Removal Tool Kit for Car Stereo/Speakers
(69)
$11.99
List price $18.99
Universal 6.5" Speaker Grills Sold as Pair
Protect your speakers with these mesh grills
(8)
$10.99
List price $12.49
6-1/2" (13.5 cm) S-Series Speaker Grills
Protect your speakers with these mesh grills
$24.00
List price $30.00
