This product works like new, is well-cared-for and in great condition. May show limited signs of wear or use and may be missing non-essential parts, accessories or original packaging.
Product Details:
2-1/2" X Series Mid-range Car Speakers
Power Handling:
Peak: 200 watts per pair / 100 watts each
RMS: 100 watts per pair / 50 watts each
CEA-2031 compliant
Anodized Aluminum cone material
Butyl Rubber speaker surround
Easily installs as a standard speaker with no custom brackets required
Mounting adapter included for direct fitment in many GM, Mopar, Toyota, Subaru, and Mercedes vehicles—simply break off the tabs needed for your application
The XQS2 includes a multi-application bracket for GM, Toyota, Chrysler, and more. Simply "snap off" the tabs that don't match your car's pattern to create a direct-fit adapter in seconds.
These are 4-ohm midrange drivers, not plug-and-play tweeters. If you didn't use a crossover or a dedicated amp channel, the signal isn't reaching them. Use an NVX X-Series crossover to properly split the signal between your door and dash.
You are sending deep bass to a 2.5" cone. Set your High Pass Filter (HPF) to 200Hz on your amp or head unit. This protects the small voice coil from over-extending and stops the distortion immediately.
The XQS2 is a "shallow mount" (1.27" deep), but if the rim is too high, remove the included decorative grille. If you still need a few millimeters, use a thin foam gasket to seat the speaker deeper into the dash opening.
These are highly sensitive. If your "Gain" is too high on the amp, you'll hear the system's "noise floor." Turn the amp gain down and the radio volume up. Also, verify your ground is on bare metal to eliminate electrical "hiss."
Check your email for the code and start saving today!
*Offer is Email Exclusive only. Contact us and we’ll help you build the system of your dreams for less.
By clicking "Get my discount!" and submitting your email, you agree to our
Terms of Service and
Privacy Policy.